Poulan 180265 owner manual Install Seat See Fig

Page 7

ASSEMBLY

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment knob.

Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

Pivot seat upward and remove from the cardboard packing. Remove the cardboard packing and discard.

Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.

Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.

Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten.

Lower seat into operating position and sit on seat.

Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

Get off seat without moving its adjusted position.

Raise seat and tighten adjustment knob securely.

SEAT

SEAT PAN

SHOULDER

BOLT

FLAT WASHER

ADJUSTMENT

KNOB

FIG. 3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

Press lift lever plunger and raise attachment lift lever to its highest position.

Release parking brake by depressing brake pedal.

Place freewheel control in freewheeling position to disengage transmission (See “TO TRANSPORT” in the Operation section of this manual).

Roll tractor forward off skid.

Remove banding holding deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Opera- tion section for location and function of con- trols)

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual.

Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

Be sure all the above assembly steps have been completed.

Check engine oil level and fill fuel tank with gasoline.

Place freewheel control in "transmission engaged" posi- tion.

Sit on seat in operating position, depress brake pedal and set the parking brake.

Press lift lever plunger and raise attachment lift lever to its highest position.

Start the engine. After engine has started, move throttle control to idle position.

Release parking brake.

Slowly depress forward drive pedal and drive tractor off skid.

Apply brake to stop tractor and set parking brake.

Turn ignition key to "OFF" position.

Continue with the instructions that follow.

7

Image 7
Contents PR20PH42STA Safe Operation Practices for Ride-On Mowers Safety Rules Table of Contents Keys Unassembled PartsSteering Wheel SeatTo Remove Tractor from Carton AssemblyTools Required for Assembly HOW to SET UP Your TractorInstall Seat See Fig Install Mulcher Plate See Fig To SET UP Your Mower for MulchingTo Convert to Bagging or Discharging Check Brake System Check Tire PressureCheck Mower Levelness Check for Proper Position of ALL BeltsOperation Battery Reverse Forward FastKnow Your Tractor HOW to USE Your Tractor To Transport See Figs To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionMulching Mowing Tips General Recommendations Service DatesLubrication Chart Customer ResponsibilitiesTires Blade Care BatteryTractor Brake OperationEngine Engine OIL Filter CleaningMuffler Spark PlugsTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Replace Mower Blade Drive Belt See Fig To Level Mower HousingBelt Removal To Replace Motion Drive Belt See Fig To Adjust Brake See FigTransmission REMOVAL/REPLACEMENT To Adjust Steering Wheel AlignmentTo Attach Jumper Cables To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove Wheel for Repairs See FigInterlocks and Relays To Replace Headlight BulbTo Replace Fuse To Adjust Carburetor Engine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsOFF Tractor Model Number PR20PH42STA SchematicIgnition Switch Wiring Insulated Clips PTO SwitchElectrical 175688 KEY Part DescriptionChassis and Enclosures Bracket Fender Drive Repair PartsTransaxle Order parts from Steering Assembly 175118 Bolt Shoulder 7/16-20 Unc 175553 Clip Optional Equipment EngineKEY Part NO. NO. Description Seat Assembly Wheels & Tires DecalsMower Lift Mower Deck Bar Adjusting Gauge Wheel Service Notes Service Notes Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service