Poulan XT22H54 manual Transaxle Motion Control Lever Neutral Adjustment See Fig, To Check Brake

Page 24

SERVICE AND ADJUSTMENTS

TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT (See Fig. 39)

The motion control lever has been preset at the factory and adjustment should not be necessary.

Loosen adjustment bolt in front of the right rear wheel, and lightly tighten.

Start engine and move motion control lever until tractor does not move forward or backward.

Hold motion control lever in that position and turn engine off.

While holding motion control lever in place, loosen the adjustment bolt.

Movemotioncontrollevertotheneutral(lockgate)position.

Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral position, follow these steps:

Loosen the adjustment bolt.

Move the motion control lever 1/4 to 1/2 inch in the direction it is trying to creep.

Tighten adjustment bolt securely.

Start engine and test.

If tractor still creeps, repeat above steps until satisfied.

MOTION CONTROL

NEUTRAL

LEVER

LOCK

 

GATE

 

ADJUSTMENT

 

BOLT

Fig. 39

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manually push the tractor forward. If the rear wheels rotate, then the brakeneedstobeserviced.Contactaqualifiedservicecenter.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO START ENGINE WITH A WEAK BATTERY (See Fig. 40)

WARNING: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

WEAK OR

FULLY CHARGED

DEAD BATTERY

BATTERY

Fig. 40

24

Image 24
Contents XT22H54 ModelSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Mower Mower Front WheelSlope Sheet KeysAssembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidTo Install Mower See Figs Assemble Front Wheel to Mower See FigFirst Install ANTI-SWAY BAR S Mower Drive Belt InstallationEngage belt tension rod K on locking bracket L Check Tire Pressure Check Deck LevelnessCheck for Proper Position of Belts Check Brake SystemOperation Know Your Tractor DP EHOW to USE Your Tractor To Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo USE Cruise Control J See Fig To Operate MowerBefore Starting the Engine To Start Engine See Fig Purge TransmissionAutomatic Transmission Warm UP Mowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning MufflerSpark Plugs Service and Adjustments To Install MowerTo Remove Mower See Fig To Replace Mower Blade Drive Belt See FigTo Level Mower Turn nut right Turn nut left To raise mowerBelt Installation To Replace Motion Drive Belt See FigTo Remove Wheel See Fig Belt RemovalTransaxle Motion Control Lever Neutral Adjustment See Fig To Start Engine with a Weak Battery See FigTo Check Brake Front Wheel TOE-IN/CAMBERTransmission Storage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionTo run when oper Battery will notFires when turn Engine continuesService Notes Outdoor Products Customer Service Dept HOPCanada contact Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAOnly Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés MAX Dept Service Customer Products Outdoor Canada AuAutorisé Garantie cette de exclus sont normal l’entretien etDentretien Remarques Dépannage DE Guide Correction Cause ProblèmeLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Starter DU Commande LA Régler Pour GAZ DES Commande LA DE Câble LE Régler PourReglages ET Revision MoteurFig la Voir Faible Rietebat UNE Avec Moteur LE Démarrer PourAvant Fig la Voir Sestesvi DE Boíte LAFig la Voir Roues LES Enlever Pour Fig la Voir D’ENTRAÎNEMENTCourroie Acer Rempl Pour 38 .FigTondeuse LA Niveau LE Ajuster Pour 36 .Fig35 .Fig 34 .FigTondeuse LA Installer Pour Fig la Voir Tondeuse LA DE LameLA DE Courroie LA Remplacer Pour Tondeuse LA Lever EN Pour 32 .Fig 31 .FigEntretien Fig La Voir Coupe DE Plateau DU Lavage DE RaccordFig la Voir ’ALLUMAGE Bougie’AIR Tamis LE Nettoyer LubrificationSionmistrans LA DE Moteur Fluide Transmission LA DE RefroidissementFig la Voir Lame LA Enlever Lames DES EntretienPneus Frein DU FonctionnementLubrification DE Tableau Utilisation Chaque AvantAvant ET Réinstallation LA Après Purgée Être UtilisationTransmission LA Purger 23 .Fig’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierQueti Maauto Transmission LA DE RéchauffementAccessoires Autres ET Charrettes DES Remorquer Pour ’ENTRETIEN/HOROMÈTRE IndicateurTracteur LE Transporter Pour Pentes LES Dans Utiliser PourFig la Voir J- Vitess DE Régulateur LE Utiliser Comment Tondeuse DE Lames LES Arrêter PourTondeuse LA Utiliser Pour Jauge DE Roues LES Régler PourGAZ DES Commande LA Utiliser Pour Fig la Voir MentReculer Pour ET Avancer Pour Létrangleur Utiliser PourFroid moteur un démarrer de permet Détrangleur Commande N 13 .FigPropriété la de lendommagement et/ou sérieuses Montage ’ENTRAÎNEMENT Courroie LA Installer Pour Tondeuse LA DE Lame LA DE12 .Fig 11 .FigCourroie LA ET Tondeuse LA Installer Figs les Voir D’ENTRAÎNEMENTFig la Voir Tondeuse LA DE Avant Roue LA Assemblez Desmancom des fonction la et Tionsec la Voir Rouler Faisant LE EN TEFig la Voir Siège LE Ajustez Palet LA DE Tracteur LE Retirer PourMontées NON Piéces Clés Pente-GuideRoue Tondeuse Arrières BiellesSommaire Sécurité DE Règles Tracteurs des sécurité touteEnfants En l’utilisation pour ConseilsAvertissement Tracteurs des sécurité toute en l’utilisation pour ConseilsPentes LES Dans Fonctionnement Général FonctionnementPelouse DE Tracteur XT22H54