Poulan PP4620AVX Limited Warranty, Troubleshooting Table Cause Remedy, Load Adjustment Engine

Page 17

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

 

TROUBLE

CAUSE

REMEDY

 

 

 

 

 

Engine will not

1. Ignition switch off.

1. Move ignition switch to ON.

 

start or will run

2. Engine flooded.

2. See “Difficult Starting” in

 

only a few

 

 

 

Operation Section.

 

seconds after

3. Fuel tank empty.

3. Fill tank with correct fuel mixture.

 

starting.

4. Spark plug not firing.

4. Install new spark plug.

 

 

5. Fuel not reaching

5. Check for dirty fuel filter; replace.

 

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

 

repair or replace.

 

 

 

 

 

 

Engine will

1.

Carburetor requires

1. See “Carburetor Adjustment” in the

 

not idle

 

adjustment.

 

Service and Adjustments Section.

 

properly.

2.

Crankshaft seals worn.

2. Contact an authorized service dealer.

 

 

 

 

 

 

 

Engine will not

1.

Air filter dirty.

1.

Clean or replace air filter.

 

accelerate,

2.

Spark plug fouled.

2.

Clean or replace plug and regap.

 

lacks power,

3.

Chain brake engaged.

3.

Disengage chain brake.

 

or dies under

4.

Carburetor requires

4.

Contact an authorized service dealer.

 

a load.

 

adjustment.

 

 

 

 

 

 

 

Engine

1. Too much oil mixed with

1. Empty fuel tank and refill with

 

smokes

 

gasoline.

 

correct fuel mixture.

 

excessively.

 

 

 

 

 

Chain moves

1. Idle speed requires

1. See “Carburetor Adjustment” in the

 

at idle speed.

 

adjustment.

 

Service and Adjustments Section.

 

 

2. Clutch requires repair.

2.

Contact an authorized service dealer.

 

 

 

 

 

 

LIMITED WARRANTY

Poulan PRO warrants to the original purchas- er that each new Poulan PRO brand gasoline chain saw is free from defects in material and workmanship and agrees to repair or replace under this warranty any defective gasoline chain saw as follows from the original date of purchase.

2 YEARS - Parts and Labor, when used for Household purposes.

60 DAYS - Parts and Labor, when used for Commercial, Professional, or Income Produc- ing purposes.

30 DAYS - Parts and Labor, if used for rental purposes.

This warranty is not transferable and does not cover damage or liability caused by improper handling, improper maintenance, or the use of accessories and/or attachments not specifical- ly recommended by Poulan PRO for this chain saw. Additionally, this warranty does not cover damage caused by improper handling, improp- er maintenance, or if the saw is altered in any way which in our judgement affects its condi- tion or operation. This warranty does not cover tune--up, spark plugs, filters, starter ropes, starter springs, chain sharpening, bars, chains, and other parts which wear and require re- placement with reasonable use during the war- ranty period. This warranty does not cover pre-

delivery set--up, installation of guide bar and chain, and normal adjustments explained in the instruction manual such as carburetor adjust- ments and chain tension adjustments. This warranty does not cover transportation costs.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

NO CLAIMS FOR CONSEQUENTIAL OR OTHER DAMAGES WILL BE ALLOWED, AND THERE ARE NO OTHER EXPRESS WARRANTIES EXCEPT THOSE EXPRESS- LY STIPULATED HEREIN.

SOME STATES DO NOT ALLOW LIMITA- TIONS ON HOW LONG AN IMPLIED WAR- RANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSE- QUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSION MAY NOT APPLY TO YOU.

The policy of Poulan PRO is to continuously improve its products. Therefore, Poulan PRO reserves the right to change, modify, or discon- tinue models, designs, specifications, and ac- cessories of all products at any time without notice or obligation to any purchaser.

17

Image 17
Contents 545123817 8/25/06 Manual de Instrucciones Manuel d’InstructionsPlan Ahead Starting ReminderMaintain Your SAW in Good Working Order Operate Your SAW SafelyHandle Fuel with Caution KickbackMaintain Control Reduce the Chance of KickbackDo not cut more than one log at a time Elbow locked Thumb on underside of handlebarChain Brake and CKA Angle Kickback Safety FeaturesComputed kickback angle CKA Table AssemblyAttaching the Bumper Spike If not already attached LoosenChecking the tension Adjusting the tensionTighten OperationKnow Your SAW Fueling & Lubrication Important Points to Remember StartingStarting a Warm Engine Difficult Starting or starting a flooded engineBraking function control Cutting MethodsInertia activating function control Important PointsNotch CUT and Felling the Tree Felling Large Trees 6 inches 15 cm in diameter or largerCutting a Fallen Tree Types of Cutting Used for BuckingBucking Without a Support Bucking Using a LOG or Support StandLimbing and Pruning Important Points LimbingCleaning the air filter ServicePruning AIR FilterCarburetor Adjustments Cleaning the Spark Arresting ScreenBAR Maintenance Idle Speed-TStorage Troubleshooting Table Cause Remedy Limited WarrantyLoad Adjustment Engine Empty fuel tank and refill withLigations The U. S. Environmental Parts List Carburetor, Ignition SystemIntermediate 125 hours Extended 300 hours