Poulan PPB2000 Inspect and Clean Unit and Decals, Replace Fuel Filter, Clean AIR Filter

INSPECT AND CLEAN UNIT AND DECALS

S After each use, inspect complete unit for loose or damaged parts. Clean the unit and decals using a damp cloth with a mild deter- gent.

SWipe off unit with a clean dry cloth.

REPLACE FUEL FILTER

To replace fuel filter, drain unit by running it dry of fuel, then remove fuel cap/retainer assem- bly from tank. Pull filter from tank and remove it from the fuel line. Install new fuel filter on fuel line; reinstall parts.

CLEAN AIR FILTER

Air Filter

Cover

Fuel Line

Fuel Filter

CHECK MUFFLER MOUNTING SCREWS

Air Filter

Screws

Once each year, ensure muffler mounting screws are secure and tightened properly to prevent damage.

Cleaning the air filter:

A dirty air filter decreases engine perform- ance and increases fuel consumption and harmful emissions. Always clean or replace air filter after every 5 hours of operation or yearly, whichever comes first.

1.Clean the cover and the area around it to keep debris from falling into the carburetor chamber when the cover is removed.

2.Remove parts as illustrated.

NOTE: Do not clean filter in gasoline or other flammable solvent. Doing so can create a fire hazard or produce harmful evaporative emis- sions.

3.Wash the filter in soap and water.

4.Allow filter to dry.

5.Apply a few drops of oil to the filter; squeeze filter to distribute oil.

6.Replace parts.

REPLACE SPARK PLUG

Replace spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.025 inch (0.6 mm). Igni- tion timing is fixed, nonadjustable.

1.Twist, then pull off spark plug boot.

2.Remove spark plug from cylinder and dis- card.

3.Replace with Champion RCJ-6Y spark plug and tighten securely with a 3/4 inch (19 mm) socket wrench.

4.Reinstall the spark plug boot.

Mounting

Screw

Muffler Cover Holes

Screws

1.Loosen and remove the 2 screws from the muffler cover.

2.Remove the muffler cover.

3.Tighten the 2 muffler mounting screws se- curely.

4.Reinstall muffler cover and 2 screws. Tighten securely.

CARBURETOR ADJUSTMENTS

There is no screw for idle adjustment on your blower. The throttle lever is used to control engine speed. The throttle lever can be placed in one of four positions: STOP, IDLE

or , FULL THROTTLE or , and one

intermittent position. If your enginewill not run properly or you require further assistance, contact an authorized service dealer or call 1--800--554--6723.

	WARNING: Perform the following		open flames from water heaters, electric
			motors or switches, furnaces, etc.
steps after each use:		S	Store unit with all guards in place. Position
S	Allow engine to cool, and secure the unit		unit so that any sharp object cannot acci-
	before storing or transporting.		dentally cause injury.
S	Store unit and fuel in a well ventilated area	S	Store unit and fuel well out of the reach of
	where fuel vapors cannot reach sparks or		children.

-- 8 --