SHOULDER STRAP ADJUSTMENT
1.Hold the unit as shown with the muffler side facing away from your body and clothes.
2.Pass the shoulder strap over your head and onto your right shoulder.
3.Extend your left arm toward the rear of the vacuum bag.
4.Adjust shoulder strap until the vacuum bag/shoulder strap seam lies between your thumb and index finger.
5.Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly.
OPERATION
KNOW YOUR BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
|
| Upper |
| Lower | Vacuum Tube |
|
| |
| Vacuum Tube |
|
|
| Primer Button |
Vacuum Bag |
| Choke Lever |
| Fuel Mix | |
| Throttle | |
| Fill Cap | |
| Lever | |
|
| |
| Spark Plug | Starter |
Elbow Tube | Rope | |
| Blower |
|
| Tube |
|
|
| Rear |
|
| Handle |
THROTTLE LEVER
The THROTTLE LEVER is used to select the desired engine speed and to stop the engine.
Move the throttle lever to the | position for |
full speed operation. Move the throttle lever
to the 
position for idle speed. To stop the engine, move the throttle lever to the STOP position.
PRIMER BUTTON
The PRIMER BUTTON removes air from the carburetor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate primer button by pressing it and allowing it to return to its origi- nal position.
CHOKE LEVER
The CHOKE helps to supply fuel to the engine to aid in cold starting. Activate the choke by moving the choke lever to the FULL CHOKE position. After engine attempts to start, move the choke lever to the HALF CHOKE position. Once engine starts, move choke lever to the RUN position.