Poulan PR25PH48STC owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 26

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

• Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be discon- nected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Maintenance sec- tion of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL

H O S E , O R T A N K D U R I N G S T O R A G E . A L S O , EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Drain the fuel tank.

Start the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during stor- age. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

26

Image 26
Contents PR25PH48STC Safety Rules Safe Operation Practices for Ride-On MowersSafety Rules Table of Contents Unassembled Parts HOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig Assemble Gauge Wheels to Mower Deck See FigInstall Mower and Drive Belt See Figs To Attach Nose Roller See FigCheck for Proper Position of ALL Belts Check Tire PressureCheck Mower Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Transport See FigsCheck Engine OIL Level Before Starting the EngineTowing Carts and Other ATTACH- Ments ADD GasolineAutomatic Transmission Warm UP Purge TransmissionMowing Tips NingService Dates MaintenanceLubrication Chart General RecommendationsTractor Engine Spark Plugs CleaningMuffler Engine OIL FilterTo Remove Mower See Fig Service and AdjustmentsTo Install Mower To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Mower Blade Drive Belt See Fig To Check and Adjust Brake See FigTo Replace Mower Drive Belt To Check BrakeTo Replace Motion Drive Belt See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Start Engine with a Weak Battery See FigReplacing Battery See Fig Interlocks and RelaysTo Adjust Choke Control See Fig To Remove Hood and Grill Assembly See FigTo Adjust Throttle Control Cable See Fig To Adjust CarburetorFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionOFF Schematic Tractor Model Number PR25PH48STCElectrical KEY Part Description 4152JChassis and Enclosures 169848X428 28 175289X428 Grille171875 169847X428Drive 178062 7211061272110614 Steering Assembly 180656 Wheel Steering 137180 Kit Spark Arrestor Flat Scrn EngineSpark Arrester 181654Seat Assembly 182493184314 DecalsWheels & Tires 184315Mower Lift Mower Deck 184058 180806179479 Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Service Notes Service Notes Parts and Service

PR25PH48STC specifications

The Poulan PR25PH48STC is a versatile and powerful tool designed to handle a variety of outdoor tasks with ease. Equipped with a robust 25cc, 2-cycle engine, this string trimmer provides ample power for tackling tough weeds, grass, and even small bushes in your yard. The engine is designed to efficiently blend fuel and air, maximizing performance while minimizing emissions, making it an efficient option for eco-conscious users.

One of the standout features of the PR25PH48STC is its innovative SureFire starting system. This technology simplifies the starting process, allowing users to start the engine with minimal effort. This feature is particularly beneficial for those who may struggle with traditional starting mechanisms, ensuring that the trimmer is ready for use when you need it most.

The trimmer boasts a 48-inch straight shaft, making it easier to reach under bushes and tight spots without straining your back. The length of the shaft also provides greater control and precision, enabling users to tackle various jobs, from edging to trimming. The PR25PH48STC comes with a 0.080-inch dual line cutting head, designed to provide a clean cut with every pass. This trimmer head offers quick line replacement, an essential feature for those who frequently use their trimmer.

Comfort is a priority in the design of the Poulan PR25PH48STC, which is evident in its ergonomic handle. With a cushioned grip, users can operate the trimmer for extended periods without discomfort. The well-balanced design further enhances maneuverability, allowing for easy adjustments while trimming around landscaping features.

In terms of durability, the PR25PH48STC is built with high-quality materials that can withstand the rigors of outdoor use. Its robust construction ensures that it can handle demanding jobs without compromising performance. Moreover, the trimmer is lightweight, making it easy to transport and maneuver without fatigue.

Overall, the Poulan PR25PH48STC represents an ideal choice for homeowners and garden enthusiasts seeking a reliable and efficient string trimmer. With its powerful engine, user-friendly features, and ergonomic design, this trimmer promises to make yard maintenance a more manageable and enjoyable task. Whether you're maintaining your lawn or tackling overgrown areas, the PR25PH48STC proves itself to be an essential gardening tool.