3.Using bar tool, roll chain around guide bar to ensure all links are in bar groove.
4.Lift up tip of guide bar to check for sag. Release tip of guide bar, then turn ad- justing screw 1/4 turn clockwise. Repeat until sag does not exist.
Adjusting Screw
5.While lifting tip of guide bar, tighten bar nuts securely with the bar tool.
Bar Nuts
6.Use the screwdriver end of the bar tool to move chain around guide bar.
7.If chain does not rotate, it is too tight. Slightly loosen bar nuts and loosen chain by turning the adjusting screw 1/4 turn counterclockwise. Retighten bar nuts.
8.If chain is too loose, it will sag below the guide bar. DO NOT operate the saw if the chain is loose.
NOTE: The chain is tensioned correctly when the weight of the chain does not cause it to sag below the guide bar (with the chain saw sitting in an upright position), but the chain still moves freely around the guide bar.
WARNING: If the saw is operated with a loose chain, the chain could jump off the guide bar and result in serious injury to the op- erator and/or damage the chain making it un- usable. If the chain jumps off the guide bar, in- spect each drive link for damage. Damaged chain must be repaired or replaced.
OPERATION
KNOW YOUR CHAIN SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Chain |
| Front Hand Guard | Front Handle |
| |
Adjustment Tool |
|
| |||
|
| Starter Rope |
| ||
(Bar Tool) |
|
|
|
| |
|
|
|
|
| |
|
|
|
| ON/STOP | Choke/ |
|
|
|
| Switch | |
| Chain | Muffler |
| Fast Idle | |
|
| Lever | |||
Bar | Bar Oil Fill Cap |
|
|
|
|
Sprocket |
|
|
|
|
|
Hole | Starter Housing | Fuel Mix Fill Cap | Primer Bulb | ||
| |||||
| Cylinder Cover |
|
|
|
|
Throttle |
| Chain |
| Chain | |
Lockout |
| Brake |
| Direction | |
Rear |
|
|
|
| of Travel |
| Adjusting Screw |
|
| ||
Handle |
|
|
| ||
|
|
|
|
| |
|
| Chain | Guide Bar | ||
Throttle |
|
|
| ||
Clutch Cover | Catcher |
|
| ||
Trigger | Bar Nuts |
|
|
|
|
ON/STOP SWITCH | THROTTLE TRIGGER |
| |||
The ON/STOP SWITCH is used to stop the | The THROTTLE TRIGGER controls engine | ||||
engine. |
| speed. |
|
|
|
8