Poulan 545186803 Assembly, Computed kickback angle CKA Table, Attaching the BAR & Chain If not

Computed kickback angle (CKA) Table

MODEL	BAR			CKA without chain brake
	P/N	Length	CHAIN P/N
PP4620AVX	952044815	20″	952051310	31_
NOTE: If this saw is to be used for commer-			SPECIAL NOTICE: Your saw is equipped
cial logging, a chain brake is required and			with a temperature limiting muffler and spark
shall not be removed or otherwise disabled			arresting screen which meets the
to comply with Federal OSHA Regulations			requirements of California Codes 4442 and
for Commercial Logging.			4443. All U.S. forest land and the states of
WARNING:			California, Idaho, Maine, Minnesota, New
	The engine exhaust		Jersey, Oregon, and Washington require by
from this product contains chemicals known			law that many internal combustion engines
to the State of California to cause cancer,			to be equipped with a spark arresting screen.
birth defects or other reproductive harm.			If you operate a chain saw in a state or locale
SAFETY NOTICE: Exposure to vibrations			where such regulations exist, you are legally
through prolonged use of gasoline powered			responsible for maintaining the operating
hand tools could cause blood vessel or nerve			condition of these parts. Failure to do so is
damage in the fingers, hands, and joints of			a violation of the law. Refer to the SERVICE
people prone to circulation disorders or			section for maintenance of the spark
abnormal swellings. Prolonged use in cold			arresting screen.
weather has been linked to blood vessel			Failure to follow all Safety Rules and Precau-
damage in otherwise healthy people. If			tions can result in serious injury. If situations
symptoms occur such as numbness, pain,			occur which are not covered in this manual,
loss of strength, change in skin color or texture,			use care and good judgement. If you need
or loss of feeling in the fingers, hands, or joints,			assistance, contact your authorized service
discontinue the use of this tool and seek			dealer or call 1-800--554--6723.
medical attention. An anti-vibration system			STANDARDS: This saw is listed by Under-
does not guarantee the avoidance of these			writer’s Laboratories, Inc. in accordance with:
problems. Users who operate power tools on			ANSI B175.1-2000 American National
a continual and regular basis must monitor			Standards for Gasoline--Powered Chain
closely their physical condition and the			Saws -- Safety Requirements
condition of this tool.			CSA Z62.1-1995Chain Saws -- Occupa-
			tional Health and Safety

CSA Z62.3-1996Chain Saw Kickback Oc- cupational Health and Safety

ASSEMBLY

Protective gloves (not provided) should be worn during assembly.

ATTACHING THE BUMPER SPIKE (If not already attached)

The bumper spike may be used as a pivot when making a cut.

1.Loosen and remove bar knob completely by lifting lever and turning counterclock- wise.

2.Remove clutch cover.

3.Attach the bumper spike with the two screws as illustrated.

ATTACHING THE BAR & CHAIN (If not

already attached)

WARNING: If received assembled, repeat all steps to ensure your saw is prop- erly assembled and all fasteners are secure. Always wear gloves when handling the

chain. The chain is sharp and can cut you even when it is not moving!

NOTE: CHAIN BRAKE MUST BE DIS- ENGAGED BEFORE IT CAN BE RE- MOVED OR INSTALLED ON THE CHAIN SAW. TO DISENGAGE CHAIN BRAKE, PULL THE FRONT HAND GUARD BACK TOWARD THE REAR OF THE CHAIN BRAKE AS FAR AS POSSIBLE (SEE ILLUSTRATION).

DISENGAGED

Front Hand Guard

ENGAGED

Chain Brake

6