Poulan 545047535 instruction manual Other, Load Adjustment Engine

Page 17

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the starter rope 8 to 10 times to distrib- ute oil.

SReplace spark plug with new one of rec- ommended type and heat range.

SClean air filter.

SCheck entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

S Replace your gasoline can if it starts to rust.

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

 

TROUBLE

CAUSE

REMEDY

 

 

 

 

 

 

 

Engine will not

1. Ignition switch off.

1.

Move ignition switch to ON.

 

start or will run

2. Engine flooded.

2.

See “Difficult Starting” in

 

only a few

 

 

 

Operation Section.

 

seconds after

3. Fuel tank empty.

3.

Fill tank with correct fuel mixture.

 

starting.

4. Spark plug not firing.

4.

Install new spark plug.

 

 

5. Fuel not reaching

5.

Check for dirty fuel filter; replace.

 

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

 

repair or replace.

 

 

 

 

 

 

 

Engine will

1.

Idle speed requires

1. See “Carburetor Adjustment” in the

 

not idle

 

adjustment.

 

Service and Adjustments Section.

 

properly.

2.

Carburetor requires

2. Contact an authorized service dealer.

 

 

 

adjustment.

 

 

 

 

Engine will not

1.

Air filter dirty.

1. Clean or replace air filter.

 

accelerate,

2.

Spark plug fouled.

2. Clean or replace plug and regap.

 

lacks power,

3.

Chain brake engaged.

3. Disengage chain brake.

 

or dies under

4.

Carburetor requires

4. Contact an authorized service dealer.

 

a load.

 

adjustment.

 

 

 

 

Engine

1.

Too much oil mixed with

1.

Empty fuel tank and refill with

 

 

smokes

 

gasoline.

 

correct fuel mixture.

 

excessively.

 

 

 

 

 

 

Chain moves

1. Idle speed requires

1. See “Carburetor Adjustment” in the

 

at idle speed.

 

adjustment.

 

Service and Adjustments Section.

 

 

2. Clutch requires repair.

2.

Contact an authorized service dealer.

17

Image 17
Contents Manual de Instrucciones Manuel d’Instructions Tions found in this manual Starting ReminderPlan Ahead Maintain Your SAW in Good Working Order Operate Your SAW SafelyHandle Fuel with Caution KickbackMaintain Control Reduce the Chance of KickbackAvoid Pinch-Kickback Avoid Pull-InChain saws as set by Ansi B175.1 Kickback Safety FeaturesChain Brake and CKA Angle Attaching the BAR & Chain If not AssemblyChecking the tension Adjusting the tensionChain Tension Operation ON/STOP Switch Throttle TriggerKnow Your Chain SAW ON/STOPCHOKE/FAST Idle Lever Throttle LOCK-OUT Chain BrakePrimer Bulb Before Starting EngineStarting a Warm Engine Important Points to RememberDifficult Starting or starting a flooded engine Right Foot Through Rear HandleInertia activating function control Braking function control Caution The chain brake must beOperating Tips Tree Felling TechniquesNotch CUT and Felling the Tree Felling Large TreesCutting a Fallen Tree Important PointsBucking Without a Support Bucking Using a LOG or Support StandLimbing and Pruning Important Points LimbingService Clean AIR Filter Inspect and Clean Unit and DecalsCleaning the Spark ARREST- ING Screen Check Fuel Mixture LevelStorage Other Load Adjustment EngineEngine Electrolux Home PRODUCTS, INC Tions The U.S. Environmental ProtectionConsequential Damages Electro