TROUBLESHOOTING TABLE
WARNING: Always stop unit and disconnect from the power source be- fore performing all of the recommended remedies below except remedies that require unit to be operating.
| TROUBLE | CAUSE | REMEDY |
| ||
|
|
|
|
|
|
|
| Chain does | 1. Chain tension incorrect. | 1. | See “Check Chain Tension” in |
| |
| not move |
|
| Maintenance section. |
| |
| when trigger | 2. Guide bar rails pinched. | 2. | Repair or replace. |
| |
| switch is | 3. Trigger switch failure. | 3. | Contact an authorized service |
| |
| engaged. | 4. Circuit breaker tripped/ |
| dealer. |
| |
|
| 4. | Reset circuit breaker or replace |
| ||
|
| fuse failure. |
| fuse. |
| |
| Chain clat- | 1. Chain tension incorrect. 1. See “Check Chain Tension” in |
| |||
| ters or cuts |
|
| Maintenance Section. |
| |
| roughly. | 2. Cutters damaged. | 2. | Contact an authorized service |
| |
|
| 3. Chain worn. |
| dealer. |
| |
|
| 3. | Resharpen or replace chain. |
| ||
|
| 4. Cutters dull, improperly | 4. | See “Chain Sharpening” in |
| |
|
| sharpened, or depth |
| Service and Adjustments section. |
| |
|
| gauges too high. |
|
|
|
|
|
| 5. Sprocket worn. | 5. | Contact an authorized service |
| |
|
|
|
| dealer. |
| |
| Chain stops | 1. Chain cutter tops not | 1. | See “Chain Sharpening” in |
| |
| during cut. | filed flat. |
| Service and Adjustments section. |
| |
|
| 2. Guide bar burred or | 2. | Repair or replace guide bar. |
| |
|
| bent; rails uneven. |
|
|
|
|
| Oil inade- | 1. Oil tank empty. | 1. Fill oil tank. |
| ||
| quate for bar | 2. Oil outlet clogged. | 2. Contact an authorized service |
| ||
| and chain |
|
| dealer. |
| |
| lubrication. | 3. Guide bar oil hole | 3. Remove bar and clean. |
| ||
|
| blocked. |
|
|
|
|
| Chain cuts | 1. Cutters damaged on | 1. See “Chain Sharpening” in |
| ||
| at an angle. | one side. |
| Service and Adjustments section. |
| |
2.Chain dull on one side. 2. See “Chain Sharpening” in Service and Adjustments section.
3.Guide bar bent or worn. 3. Replace guide bar.
15