Infinity PS-8 Subwoofer Connections, This figure shows how to connect bare wires to the terminals

Page 5

SUBWOOFER CONNECTIONS

CHOOSE THE SUBWOOFER CONNECTION THAT IS MOST SUITABLE FOR YOUR RECEIVER/PROCESSOR

If you have a Dolby* Digital or DTS® receiver/processor with a low-frequency-effects (LFE) or subwoofer output:

If your receiver/processor does not contain a Dolby Digital or DTS processor but has a subwoofer output:

RECEIVER/PROCESSOR

SUBWOOFER OR

LFE OUTPUT

L R

OUT IN

++

If your receiver/processor does not have subwoofer outputs for the left and right channels or an LFE output, connect speaker wire from your receiver/amplifier to your speakers and subwoofer using two sets of speaker wire:

RECEIVER/AMPLIFIER

Front Speaker Output

HIGH LEVEL INPUT

 

+

 

L

R

OUT IN

++

NOTE: Some receivers have one subwoofer output.

In that case, it is recommended that you use a Y connector (not included) to maximize performance.

RED = +

BLACK =

1.LOOSEN TERMINALS

2.INSERT BARE END; TIGHTEN TERMINALS

NO STRIPE =

 

STRIPE = +

 

 

 

 

 

 

This figure shows how to connect bare wires to the terminals.

PS-8 5

Image 5
Contents PS-8 Read First Introduction PlacementInfinity PS-8 Unpacking the Subwoofer£ ¢ ∞ Controls and ConnectionsRear Panel Subwoofer Connections This figure shows how to connect bare wires to the terminalsOperation Maintenance and ServicePS-8 SpecificationsDimensions H x W x D