Poulan 178108 Replacing Battery See Figs, To Replace Headlight Bulb, Interlocks and Relays

Page 22

SERVICE AND ADJUSTMENTS

POSITIVE TERMINAL

NEGATIVE TERMINAL

CHASSIS

 

 

CABLES

 

CHARGED

 

BATTERY

POSITIVE TERMINAL

NEGATIVE TERMINAL

FIG. 27

REPLACING BATTERY (See Figs. 28 and 29)

CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acciden- tal grounding.

•Lift seat pan to raised position and open battery box door.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

•Close battery box door.

SEAT PAN

BATTERY

BOX DOOR

FIG. 28

KEPS

NUT

HEX

BOLT

POSITIVE (RED)

NEGATIVE

CABLE

(BLACK) CABLE

FIG. 29

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 30)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT WIRE CONNECTOR

FIG. 3

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents PRK17G42STB Safety Rules Safe Operation Practices for Ride-On MowersTable of Contents Product Specifications Customer ResponsibilitiesContents of Hardware Pack To Remove Tractor from Carton Tools Required for AssemblyHOW to SET UP Your Tractor Before Removing Tractor from SkidInstall Seat See Fig Check Tire Pressure To SET UP Your Mower for MulchingTo Convert to Bagging or Discharging Check Deck LevelnessEngine on Engine OFF OIL Pressure Lights on Battery Reverse Forward FastSee Safety Rules Section LightKnow Your Tractor HOW to USE Your Tractor Towing Carts and Other Attachments Before Starting the EngineTo Transport ADD GasolineTo Start Engine See Fig Mowing TipsMulching Mowing Tips General Recommendations Lubrication ChartBefore Each USE Tractor Engine Spark Plugs CleaningMuffler Engine OIL FilterTo Install Mower See Fig To Remove Mower See FigTo Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Mower Blade Drive Belt See Fig To Adjust Brake See FigBelt Installation To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transaxle Gear Shift Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb Replacing Battery See FigsTo Remove Hood and Grill Assembly See Fig Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust CarburetorEngine OIL OtherFuel System CylindersTroubleshooting Points OFF Schematic Tractor - Model Number PRK17G42STBElectrical 2122KEY Part NO. NO.DESCRIPTION 142 174619 Chassis and Enclosures176554 Drive 73900600 175410175765 175578Steering Assembly 175146 175121177876 175118Seat Assembly 178108 DecalsWheels and Tires 178109Engine 170805 Control Th/ch Flag Mower Deck 174493 Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Service Notes Limited Warranty Policy Suggested Guide for Sighting Slopes for Safe Operation Sighting GuideParts and Service
Top Page Image Contents