Poulan 530165228 instruction manual Need ASSISTANCE?

Page 16

STORAGE

WARNING: Stop engine and allow to cool, and secure the unit before storing or transporting in a vehicle. Store unit and fuel in an area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. Store unit with all guards in place. Position so that any sharp object cannot accidentally cause injury to passersby. Store the unit out of reach of children.

SBefore storing, drain all fuel from the unit. Start engine and allow to run until it stops.

SClean the unit before storing. Pay particu- lar attention to the air intake area, keeping it free of debris. Use a mild detergent and sponge to clean the plastic surfaces.

SDo not store the unit or fuel in a closed area where fuel vapors can reach sparks or an

open flame from hot water heaters, electric motors or switches, furnaces, etc.

SStore in a dry area out of the reach of chil- dren.

TROUBLESHOOTING TABLE

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

CAUTION: It is important to prevent gum deposits from forming in essential fuel system parts such as the carburetor, fuel filter, fuel hose, or fuel tank during storage. Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to fuel mixture separation and formation of acids during storage. Acidic gas can damage the engine.

NEED ASSISTANCE?

NEED ASSISTANCE?

Call 1--800--554--6723.

NEED SERVICE PART?

Contact your dealer or place of purchase.

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

 

TROUBLE

CAUSE

REMEDY

 

 

 

 

 

 

 

Engine will not

1. Ignition switch off.

1.

Move ignition switch to ON.

 

start or will run

2. Engine flooded.

2.

See “Difficult Starting” in

 

only a few

 

 

 

Operation Section.

 

seconds after

3. Fuel tank empty.

3.

Fill tank with correct fuel mixture.

 

starting.

4. Spark plug not firing.

4.

Install new spark plug.

 

 

5. Fuel not reaching

5.

Check for dirty fuel filter; replace.

 

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

 

repair or replace.

 

 

 

 

 

 

 

Engine will

1.

Idle speed requires

1. See “Carburetor Adjustment” in the

 

not idle

 

adjustment.

 

Service and Adjustments Section.

 

properly.

2.

Carburetor requires

2. Contact an authorized service dealer.

 

 

 

adjustment.

 

 

 

 

Engine will not

1.

Air filter dirty.

1. Clean or replace air filter.

 

accelerate,

2.

Spark plug fouled.

2. Clean or replace plug and regap.

 

lacks power,

3.

Chain brake engaged.

3. Disengage chain brake.

 

or dies under

4.

Carburetor requires

4. Contact an authorized service dealer.

 

a load.

 

adjustment.

 

 

 

 

 

 

 

 

 

 

 

Engine

1.

Too much oil mixed with

1.

Empty fuel tank and refill with

 

smokes

 

gasoline.

 

correct fuel mixture.

 

excessively.

 

 

 

 

 

 

Chain moves

1. Idle speed requires

1. See “Carburetor Adjustment” in the

 

at idle speed.

 

adjustment.

 

Service and Adjustments Section.

 

 

2. Clutch requires repair.

2.

Contact an authorized service dealer.

16

Image 16
Contents Manual de Instrucciones Manuel d’Instructions English Español FrançaisIdentification of Symbols Safety RulesHearing Safety Hat Protection Eye Snug Fitting Plan AheadOperate Your SAW Safely Maintain Your SAW in Good Working OrderHandle Fuel with Caution KickbackReduce the Chance of Kickback Kickback Safety FeaturesMaintain Control BAR Chain Brake and CKA AngleChain P/N Assembly Attaching the BAR & Chain If notMount the Bar Tip BarChain Tension Including units with chain already installed Adjusting the tensionChecking the tension CuttersOperation Starting Fueling EngineBAR and Chain Lubrication Important Points to RememberCutting Methods Starting a Warm EngineDifficult Starting or starting a flooded engine Inertia activating function controlFelling Large Trees Tree Felling TechniquesNotch CUT and Felling the Tree Bucking Using a LOG or Support Stand Cutting a Fallen TreeTypes of Cutting Used for Bucking Bucking Without a SupportService Limbing and Pruning Important PointsLimbing PruningCleaning the air filter Cleaning the Spark ARREST- ING ScreenMaintenance Schedule AIR FilterCarburetor Adjustment BAR MaintenanceChain Sharpening Ignition TimingNeed ASSISTANCE? Limited Warranty Your Warranty Rights and ObligaOWNER’S Warranty Responsibili Tions The U.S. Environmental ProtectionPlacement and Repair of Emission Sion Control Warranty Parts List