Poulan 530086680 Know Your SAW, ON/STOP Switch, Throttle Trigger, Throttle Lockout, Primer Bulb

KNOW YOUR SAW

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

Chain	Front Hand Guard	Front Handle
Adjustment Tool
(Bar Tool)		Starter Rope
		ON/STOP
		Switch
Chain	Muffler
			Primer
			Bulb

		Bar Oil Fill Cap	Starter	Fuel Mix Fill Cap
			Housing
		Cylinder Cover
	Throttle				Chain
					Direction
Rear	Lockout		Adjusting
			Screw		of Travel
Handle

Throttle	Choke/	Chain	Chain	Chain Brake Nuts	Guide Bar
Trigger	Fast Idle
	Lever	Brake	Catcher

ON/STOP SWITCH

The ON/STOP SWITCH is used to stop the engine.

THROTTLE TRIGGER

The THROTTLE TRIGGER controls engine speed.

THROTTLE LOCKOUT

The THROTTLE LOCKOUT must be pressed before you can squeeze the throttle trigger. This feature prevents you from accidentally squeezing the trigger.

CHOKE/FAST IDLE LEVER

The choke and fast idle are set by pulling the CHOKE/FAST IDLE LEVER out fully for cold or refueled starting. The choke provides addi- tional fuel to the engine during cold starting.

PRIMER BULB

The PRIMER BULB circulates fuel to the carburetor to provide quicker starting.

CHAIN BRAKE

The CHAIN BRAKE is a device designed to stop the chain if kickback occurs. The chain brake activates automatically in the event of kickback. The chain brake activates manu- ally if the front hand guard is pushed forward. The chain brake is disengaged by pulling the front hand guard back toward the front han- dle as far as possible.

CHAIN TENSION

It is normal for a new chain to stretch during first 30 minutes of operation. You should check your chain tension frequently. See CHAIN TENSION under the ASSEMBLY section.

WARNING: Muffler is very hot dur- ing and after use. Do not touch the muffler or allow combustible material such as dry grass or fuel to do so.

8