Know Your SAW, ON/STOP Switch, Throttle Trigger

KNOW YOUR SAW

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

Chain

Front Hand Guard

Front Handle

Adjustment Tool

(Bar Tool)

Starter Rope

ON/STOP

Switch

Chain

Muffler

Primer

Bulb

Bar

Sprocket Hole

Bar Oil Fill Cap

Starter

Fuel Mix Fill Cap

Housing

Cylinder Cover

Throttle

Chain

Rear Lockout

Direction

Adjusting

of Travel

Handle

Screw

Throttle	Choke/	Chain	Chain	Chain Brake Nuts	Guide Bar
Trigger	Fast Idle	Chain	Chain
	Lever	Brake	Catcher
	Lever

ON/STOP SWITCH

The ON/STOP SWITCH is used to stop the engine.

THROTTLE TRIGGER

The THROTTLE TRIGGER controls engine speed.

THROTTLE LOCKOUT

The THROTTLE LOCKOUT must be pressed before you can squeeze the throttle trigger. This feature prevents you from accidentally squeezing the trigger.

CHOKE/FAST IDLE LEVER

The choke and fast idle are set by pulling the CHOKE/FAST IDLE LEVER out fully for cold or refueled starting. The choke provides addi- tional fuel to the engine during cold starting.

PRIMER BULB

The PRIMER BULB circulates fuel to the carburetor to provide quicker starting.

CHAIN BRAKE

The CHAIN BRAKE is a device designed to stop the chain if kickback occurs. The chain brake activates automatically in the event of kickback. The chain brake activates manu- ally if the front hand guard is pushed forward. The chain brake is disengaged by pulling the front hand guard back toward the front han- dle as far as possible.

CHAIN TENSION

It is normal for a new chain to stretch during first 30 minutes of operation. You should check your chain tension frequently. See CHAIN TENSION under the ASSEMBLY section.

WARNING: Muffler is very hot dur- ing and after use. Do not touch the muffler or allow combustible material such as dry grass or fuel to do so.