Infinity FIFTEEN manual Connections, Set Normal/LFE Switch to LFE, Set Normal/LFE Switch to Normal

Page 6

CONNECTIONS

If you have a Dolby® Digital or DTS® receiver/processor with a low-frequency-effects (LFE) output:

SUBWOOFER OR

LFE OUTPUT

• Set Normal/LFE Switch to LFE.

NOTE: In this case, you do not need to use a Y-connector. Simply connect the LFE output on your receiver/processor to either the left or right input on the subwoofer.

If your receiver/processor has subwoofer outputs for the left and right channels:

• Set Normal/LFE Switch to Normal.

NOTE: Some receivers have a single subwoofer output (do not confuse this with a single LFE output as described to the left). In that case, it is recommended that you use a Y-connector (not included) to maximize performance.

SUBWOOFER OR

LFE OUTPUT

OR

The Cascade Model Fifteen also includes a set of line outputs. These outputs allow you to “daisy-chain” one Model Fifteen to multiple Model Fifteen subwoofers. Simply connect the first subwoofer as described above and then run a subwoofer cable from the line output(s) to the line input(s) on the next sub.

NOTE: This line output is before the R.A.B.O.S. circuit. Each sub- woofer’s R.A.B.O.S. controls must be individually adjusted during the R.A.B.O.S. setup.

3CASCADE MODEL FIFTEEN

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Cascade Upon completion of any service or repairs Read FirstIi Cascade Model Fifteen Table of Contents Placement Infinity Cascade Model FifteenUnpacking the Subwoofer Controls and Connections Rear Panel ¡ £ ¢ ∞ §Set Normal/LFE Switch to LFE Set Normal/LFE Switch to NormalConnections Power On OperationRoom Adaptive Bass Optimization System R.A.B.O.S Contents of the R.A.B.O.S.Test CD Rslm PlacementTurn the system volume to minimum Initial System-Level SettingSetting the Subwoofer Test Level When you have completed this adjustment, press PauseLocating a test point Frequency What Does a Parametric Equalizer Do?Completing the Measurement Template WidthUsing the Width Selector Placement of the Width SelectorWhat You Measure, What to Do Skip to the Adjusting the R.A.B.O.S. Equalizersection onLevel Our example, you would enter 9 in the attenuation fieldExample 2. Two Response Peaks Example 3. Peak Adjacent to a DipExample 4. Narrow Response Example of two narrow dipsAdjusting the R.A.B.O.S. Equalizer Example 6. Ideal ResponsePosition Final System Balance Cascade Model Fifteen R.A.B.O.S. ControlsMaintenance and Service Frequency Frequency Specifications Cascade Model Fifteen
Related manuals
Manual 25 pages 20.38 Kb
Top Page Image Contents