Poulan 545137281 instruction manual Seasonal Storage, Fuel System, Engine, Other

Page 16

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool before storing or trans- porting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric

motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci-

dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time: S Clean the entire unit before lengthy

storage.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through

the spark plug opening. Slowly pull the starter rope 8 to 10 times to distribute oil.

SReplace spark plug with new one of recom-

mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to another.

SReplace your gasoline can if it starts to rust.

16

Image 16
Contents SM446E Safety Rules Identification of SymbolsPlan Ahead Operate Your Pruner Safely Maintain Your Pruner in Good Working OrderHandle Fuel with Caution KickbackKickback Safety Features Reduce the Chance KickbackMaintain Control TipEdger Safety Line Trimmer SafetyBLOWER/VACUUM Safety For Optional AttachmentsBrushcutter Safety Cultivator SafetyProper air flow Curs, stop the engine and inspect the unit for damageHedge Trimmer Safety Snow Thrower SafetyHead Essary before restarting unitAssembly Installing Pruner ATTACH- MentShoulder Strap Assembly Tools RequiredOperation HOW to Stop Your Unit HOW to Start Your UnitBAR and Chain Lubrication Starting a Cold EngineInstalling Attachment Hanger Installing Optional ATTACH- MentsOperating the Coupler Removing Pruner Attachment or Other Optional Attach MentsPruning Technique Pruning Important PointsFoot Maintenance Service and Adjustments Chain Adjustment Carburetor AdjustmentIdle Speed Adjustment To Replace ChainSeasonal Storage Fuel SystemEngine OtherTroubleshooting Table Cause Remedy Load AdjustmentCompression low Carbon build-up onLimited Warranty Is Covered Repair or ReplaceIntermediate 125 hours Extended 300 hours