3.Position the lower shoulder strap clamp under the upper shaft and align the upper and lower clamp screw holes.
Upper Shoulder
Strap Clamp
POWERHEAD
END
Lower Shoulder | ATTACHMENT | |
END | ||
Strap Clamp | ||
| Screws |
4.Insert two screws into the screw holes.
5.Secure shoulder strap clamp by tighten- ing screws with a hex wrench.
ADJUSTING THE ASSIST HANDLE
WARNING: When adjusting the as- sist handle, be sure it remains between the
coupler and the | lower arrow (closest to |
coupler) on the safety label to ensure proper
1.Loosen wing nut on handle.
2.Rotate the handle on the shaft to an up- right position; retighten wing nut.
ATTACHING SHIELD (FOR LINE TRIMMER ATTACHMENT)
WARNING: The shield must be prop- erly installed. The shield provides partial protec- tion from the risk of thrown objects to the opera- tor and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you. For proper orientation of shield, see KNOW YOUR TRIM- MER illustration in OPERATION section.
1.Remove wing nut from shield.
2.Insert bracket into slot as shown.
3.Pivot shield until bolt passes through hole in bracket.
4.Securely tighten wing nut onto bolt.
Slot
Shield
Bracket
balancing of unit. When adjusting the assist handle or handlebar during use of optional at- tachments, it must be repositioned between
the throttle trigger and the 
upper arrow (closest to engine) on the safety label.
Line Limiter Blade
Wing
Nut
OPERATION
KNOW YOUR PRUNER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
|
|
| Assist Handle | ON/OFF Switch | |
|
|
| Coupler | ||
Pruner |
|
|
|
| |
Line Trimmer | Shaft |
| Shoulder Strap Clamp | Fuel mix | |
|
|
|
| ||
Attachment | Attachment Hanger | Starter Handle |
| fill cap | |
|
|
|
| ||
|
|
|
|
| Primer |
|
| Bar oil fill cap |
| Bulb | |
|
|
|
| ||
Shield | Chain |
| Throttle Trigger |
|
|
|
|
|
| ||
|
|
|
|
| |
| Bar | Bar nut | Choke Lever |
| Muffler |
|
|
| |||
|
|
|
|
| |
ON/OFF SWITCH
The ON/OFF switch is located on the trigger handle and is used to stop the engine. Move the switch to the OFF position to stop the engine.
PRIMER BULB
The PRIMER BULB removes air from the car- buretor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its origi- nal form.
9