Poulan PP6600E manual General Maintenance, CLEANING/REPLACING AIR Filters, Changing Engine OIL

Page 18

MAINTENANCE

WARNING:

When servicing, use only identical Poulan Pro replacement parts. Use of any other parts may create a hazard or cause product damage.

Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at a Poulan Pro Authorized Service Center.

GENERAL MAINTENANCE

Keep the generator in a clean and dry environment where it is not exposed to dust, dirt, moisture, or cor- rosive vapors. Do not allow the cooling air slots in the generator to become clogged with foreign material such as leaves, snow, etc.

Do not use a garden hose to clean the generator. Water entering the fuel system or other internal parts of the unit can cause problems that will decrease the life of the generator.

To clean the unit:

Use a soft bristle brush and/or vacuum cleaner to loosen and remove dirt and debris.

Clean air vents with low pressure air that does not exceed 25 psi.

Wipe the exterior surfaces of the generator with a damp cloth.

CLEANING/REPLACING AIR FILTERS

For proper performance and long life, keep air filters clean:

Release the upper and lower retaining clips and remove the air filter cover.

Remove the outer filter element and the inner precleaner element.

If the filter elements are dirty, clean with warm, soapy water. Rinse and let dry.

Apply a light coat of engine oil to the elements, then squeeze it out.

Put the filter elements back together and replace in the air filter compartment, being careful to place the outer filter element closest to the air filter cover.

Replace the cover and snap retaining clips back in place to secure.

NOTE: Do not run the generator without the air filters. Rapid engine wear will result.

CHANGING ENGINE OIL

to collect used oil as it drains.

Unscrew the oil drainage bolt and remove.

Allow oil to drain completely.

Fig. 12

OIL DIPSTICK

OIL FILL

OIL DRAINAGE TUBE

BOLT

Fig. 13

Reinstall the oil drainage bolt and tighten securely.

Refill with oil following the instructions in the "Checking/Adding Oil"section on page 15.

18

Image 18
Contents Model PP4300/PP6600/PP6600E/PP7600E Table of Contents IntroductionSafety Rules When Adding FuelUnintentional sparking can result in fire or electric shock Symbols NameService HOT Features Specifications120/240 Volts AC Grounding Terminal Engine SwitchKnow Your Generator ReceptaclesAssembly Unassembled Parts Instructions AssemblyInstalling Handle Assembly Packing ListInstalling Wheel Assembly Installing Foot AssemblyOperation Grounding the GeneratorCHECKING/ADDING OIL ApplicationsBefore Operating the Unit CHECKING/ADDING FuelStarting the Engine Stopping the EnginePower Management ElectricalCapacity CLEANING/REPLACING AIR Filters MaintenanceGeneral Maintenance Changing Engine OILDraining Carburetor Cleaning Fuel Sediment CUPSpark Plug Maintenance TransportingStorage Maintenance ScheduleStorage Storage Time Prior to StoringTroubleshooting ProblemWarranty Manufacturers Warranty CoverageII. Emission Control System Warranty Warranty Emissions Maintenance Schedule and Warranted Parts List Limited Warranty Service Notes Service Model NO. and Serial no HOW to Order Repair Parts