Oregon Scientific BAR629HG Data Transmission, Search for Sensor, Turn Clock on / OFF

SWITCH	OPTION
Channel	Channel 1-3. If you are using more than
	one sensor, select a different channel for
	each sensor.

3.Set the channel. The switch is located in the battery compartment.

4.Place the sensor near the main unit. Press RESET on the sensor. Then, press and hold MEMORY and CHANNEL on the main unit to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the “Sensor Data Transmission” section for more information.)

5.Close the remote sensor battery compartment.

6.Secure the sensor in the desired location using the wall mount or table stand.

For best results:

•Insert the batteries and select the channel before you mount the sensor.

•Place the sensor out of direct sunlight and moisture.

•Do not place the sensor more than 30 metres (98 feet) from the main (indoor) unit.

•Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture.

•Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects.

•Position the sensor close to the main unit during cold winter months as below-freezing temperatures may affect battery performance and signal transmission.

You may need to experiment with various locations to get the best results.

DATA TRANSMISSION

Data is sent from the sensor(s) every 40 seconds. The reception icon shown in the Temperature and Humidity Areas show the status.

ICON	DESCRIPTION
	Main unit is searching for
	sensors.
	At least 1 channel has been
	found.
	Channel 1 is selected (number
	will change depending on the
	sensor you select)

---shows in Outdoor The selected sensor cannot Temp / Humidity Area be found. Search for the

sensor or check batteries.

SEARCH FOR SENSOR

To search for a sensor, press and hold MEMORY and CHANNEL (on the main unit) for 2 seconds.

NOTE If the sensor is still not found, check the batteries, obstructions, and remote unit location.

NOTE Signals from household devices such as doorbells, electronic garage doors, and home security systems may cause temporary reception failure. This is normal and does not affect general product performance. The reception will resume once the interference ends.

CLOCK

The clock automatically synchronizes the current time and date when it is brought within range of the radio signal DCF77 generated from Frankfurt, Germany for Central Europe (model BAR629HG) or MSF60 generated from Rugby, England (model BAR629HGU).

NOTE The signals are collected by the main unit when it is within 1500 km (932 miles) of a signal.

Initial reception takes 2-10 minutes, and is initiated when you first setup the unit, and whenever you press RESET. Once complete, the reception icon will stop blinking. The icon is shown in the Clock Area.

STRONG SIGNAL WEAK SIGNAL NO SIGNAL

To force a manual search for clock signals, press and hold for 2 seconds. If no signal is found, check the batteries.

TURN CLOCK ON / OFF

Perform this step if you cannot receive clock signals. Press and hold for 2 seconds. Then, manually set the clock following the “Set Clock” instructions (below).

The signal icon indicates that the clock feature is ON. No icon means that it is OFF.

SET CLOCK / CALENDAR

You only need to do this if you have disabled the clock feature (for example, if you are too far from or cannot receive a signal).

1.Press and hold MODE for 2 seconds. The Clock Area will blink.

2.Select the hour, minute, year, month, day, and day of the week language. Press or to change the setting.

3.Press MODE to confirm.

The language options are (E) English, (F) French, (D) German, (I) Italian, and (S) Spanish.

EN

5