Infinity CC-2 owner manual Wiring the System

TURN OFF ALL POWER...

IMPORTANT!

IMPORTANT!

Figure 4. The CC-2 center-channel speaker features gold-plated terminals that can be connected in several different ways; e.g., banana plugs, spade terminals, and direct wiring (as shown here).

WIRING THE SYSTEM

After placing the speaker, you are ready to connect it to your system. First turn off all audio system power. Use high-quality speaker wire to make the connections. Consult the owner’s manuals (included with your amplifier, receiver, or television) for connection and operation procedures.

When using the CC-2 for center-channel reproduction, set the center- channel mode (on a Dolby Pro Logic preamplifier or A/V receiver) to NORMAL. This will route the low frequencies (below 100 Hz) away from the center-channel speaker to the front left and right speakers.

Observe polarities when making speaker connections, as shown in Figures 4 (below) and 5 (on the next page). Connect the appropriate

+terminal on the back of the amplifier, receiver, or television to the respective + (red) terminal on the CC-2 speaker. Similarly, connect the

– (black) terminals in the same way.

Do not reverse polarities (i.e., + to - or - to +) when making connections.

CC-2

(rear view)

❶Loosen Terminal

	❷ Insert Bare End	Black = –
	End; Tighten
	Terminal
	Stripe = –
Speaker
Wire	No Stripe = +
		Red = +

CONNECTING SPEAKERS DIRECTLY TO WIRES

4 ◆ Infinity CC-2 Center-Channel Speaker Owner’s Manual