Robic SC-554 manual LAP/SPLIT Chronograph Operation, Speed Timer Operation, Distance Entered

Page x of y

Rev 02 05/04/05

Single Events: Press “A” to start. Press “A” again to stop. Press “B” to reset to all zeros.

Timing Multiple Splits: Press “A” to start. “RUN” indicator appears and time is shown running in the lower row of the display. Press “B” to take a Split time. The Split time appears in the upper row of the display, while the accumulated running time appears in the lower row. The LAP COUNTER will increase by one (1) each time “B” is pressed. The SC-554 will take up to 999 Split times.

Press “A” to stop. “STOP” indicator appears. LAP COUNTER will increase by one (1) when the timer is stopped. Press “B” once, to view the total accumulated time of the event. Then, press “B” again to reset your SC-554 Chronograph to all zeros.

LAP/SPLIT Chronograph Operation

Please note that “LAP/SPL” is commonly referred to as “dual split” timing.

While in the Chrono (CHR) mode, press “C” until “LAP/SPL” indicator appears.

Single Events: Press “A” to start. Press “A” again to stop. Press “B” to reset to all zeros.

Timing Multiple Dual Splits: Press “A” to start. “RUN” indicator appears. Time is shown running in both the upper and lower rows of the display. LAP COUNTER will show “001” indicating this is the first segment.

Press “B” to take a Dual Split time reading. The time reading will appear frozen in the upper and lower rows of the display. You may press “E” to release the frozen display to the current running LAP and SPLIT times, or the SC-554 will automatically do so after 15 seconds.

Upon releasing the frozen time display, the LAP COUNTER will increase by one (1) to indicate the second segment is now displayed.

The SC-554 will take up to 999 Dual Split readings. You may recall up to the previous 30 at any time by pressing “F”.

To stop the Chrono, press “A”, then, press “B” to reset to all zeros.

NOTES:

¾After 24 hours or 999 laps, the chronograph will cease operation.

¾The time value in the upper row will have 1/100 second resolution for the first 60 minutes. After 60 minutes, it will have one (1) second resolution up to 24 hours. The time value in the lower row will have 1/100 second resolution for up to 24 hours.

¾If no pushbutton is pressed for 15 seconds, the SC-554 will return to the last previous time value if MEMORY RECALL and AVG/MAX functions are activated.

PART IV

SPEED TIMER Operation

The Speed Timer will compute and display speed in MPH or KPH as a function of distance and time.

To enter the SPEED mode from NORMAL TIME, press “E” twice. Should numbers other than all zeros appear in the lower row of the display.

(1)If the “STOP” indicator appears, press “B” to reset to all zeros

(2)If the “RUN” indicator appears, press “A” , then “B”.

The SPEED TIMER will NOT operate unless a distance has been entered.

Distance Entered:

0.250 Mile (1/4 mile)