Padlock Installation Instructions for ALL Units

PADLOCK INSTALLATION INSTRUCTIONS FOR ALL UNITS

Figure 1

U-Bolt

Figure 2	Lock Shackle

7/8"-1"

Figure 3

(measure height

when lock is closed)

TOOLS REQUIRED- One wrench with 7/16” socket.		3.	Guide the U-bolt through the two holes in the back of
PADLOCK INFORMATION- Padlock with 7/8”–1” shackle			the lock housing (figure 2).
height (figure 3) (recommended Master No 5 or equiva-		4.	Secure the U-bolt with the two nylon lock nuts sup-
lent, not included).			plied.
		5.	Repeat the procedure for the second lock.
1.	Open your padlock and slide the U-bolt over the lock	6.	To lock, close lid and push bottom of padlock until
	shackle.		lock “clicks” closed.
2.	Slide the lock through the lock housing on the front of	7.	To open, turn key and open lid.
	the box (figure 1).

3068-OS PROP-ARM INSTRUCTIONS

PROP

ARM

LOCKING SUPPORT ARM

Figure 4

TOP POINT

FOR FIELD DESK CAPABILITY

1.Hold cover in the middle with one hand, pull left prop arm outward and disengage from retaining clasp.

2.Switch hands on cover and repeat (figure 4) for oppo- site side.

3.Hold the cover at it’s top point with your right hand. With your left hand, slightly pull the locking support arm at the hinge until there is a slight bend (figure 4).

4.Slowly lower cover until it is parallel with the ground. Be sure the prop arms are engaged in slots as shown below (figure 5). Make sure prop arms are fully engaged forward so that the prop arms are perpen- dicular to the cover.

5.The final position for Field Desk Capability is shown in Figue 6

Figure 5

SIDE

VIEW

ENGAGEMENT

POINT

Figure 6

WARNING

Do NOT use cover as a step.