RIDGID R2400 manual Using Edge Guide, Edge Guide Thumb Screws

Page 17

USING EDGE GUIDE

��Use the edge guide to trim or cut a straight edge. n Unplug the laminate trimmer.

n Thread guide bars into the base and tighten with a flat head screwdriver.

n Slide the edge guide onto the guide bars.

n Remove the two thumb screws from the bearing guide assembly and install into the edge guide.

n Measure the proper distance to offset the cutter, or if trim- ming, position the cutter at the edge of the workpiece.

n Tighten the two thumb screws to secure the edge guide.

n Move the trimmer along the workpiece keeping the edge guide in constant contact with edge of the workpiece.

Fig. 14

Image 17

Contents Double Insulated OPERATOR’S ManualIntroduction Table of ContentsElectrical Safety General Safety RulesPersonal Safety Work AreaService Specific Safety RulesSymbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Double Insulation ElectricalElectrical Connection Extension CordsLighted Plug FeaturesProduct Specifications Assembly Motor Housing INSTALLING/REMOVING CuttersSee Figures 2 BaseToggle Switch Decrease Speedincrease Speed Adjusting the SpeedOperation ApplicationsOperating the Laminate Trimmer See Figures 7 Direction of Feed and ThrustGrains First Trim END Direction Feed Trimmer BITForce Feeding Proper Rate of FeedTOO Slow Feeding TOO Slow TOO Fast1ST. Pass Depth of CUTDepth Width CUT See Figures 12 Setting Depth of CUTTo USE Bearing Guide Assembly Edge Guide Thumb Screws Using Edge GuideGeneral Maintenance MaintenanceBrush Replacement LubricationDAY Satisfaction Guarantee Policy WarrantyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information