Assembly Instructions | Scag Power Equipment GC-STT-V guide

3.1 ASSEMBLY INSTRUCTIONS

-NOTE-

Use the illustrated parts list as a part

number reference when following the

assembly instructions.

1.Remove all packaging materials. Lay out the mounting hardware and the catcher assembly parts for easy access. Prepare the work area making sure that it is a clean, safe environment.

2.Remove the discharge chute from the cutter deck. See Figure 3-1.

INSTALL PULLEY

ON RH SPINDLE SHAFT -

ON TOP OF EXISTING

SPINDLE DRIVE

3.Remove the right side belt cover to gain access to the spindle assembly. Remove the u-nuts from the cutter deck bracket. See Figure 3-1.

4.Install the grass catcher pulley onto the spindle assembly. Apply loctite to both pulley setscrews and tighten. See Figure 3-1.

5.Remove the "Custom-Cut" and "Turbo" baffles from the cutter deck. Using the original hardware, install the new "Front" and "Turbo" baffles. See Figure 3-2.

Front Baffle

52V - 424402

61V - 424403

Turbo Baffle

PULLEY

REMOVE EXISTING RT. SIDE BELT

52V - 424211

61V - 424212

REMOVE DISCHARGE CHUTE AND HARDWARE

REMOVE (2) U-NUTS

COVER

RIGHT SIDE OF 52"

CUTTER DECK SHOWN

UNDER SIDE OF

VELOCITY-PLUS

CUTTER DECK SHOWN

FIGURE 3-2

-NOTE-

(Note: Some parts not shown for viewing purposes.)

FIGURE 3-1

-NOTE-

Do not discard the discharge chute or mounting hardware. The discharge chute MUST be reinstalled anytime the grass catcher has been removed from the machine.

WARNING

DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING KIT, OR ENTIRE GRASS CATCHER INSTALLED

Do not discard the original "Custom-Cut" or "Turbo" baffles. These baffles may be reinstalled anytime the grass catcher has been removed from the machine.

6.Install the blower mounting bracket to the deck using 1/2-13 x 1-1/2" hex head bolts (p/n 04001- 71), 1/2" spring lockwashers (p/n 04030-06), and 1/2-13 elastic stop nuts (p/n 04021-07). See Figure 3-3, Page 3 for 52" decks and Figure 3-4, page 4 for 612"decks. Do not fully tighten the hardware at this time.

7.This step is for 52" cutter decks only. Block the right front side on the cutter deck and remove the hang chain. Install the deck lift link. Secure using hex head bolts (p/n 04001-32,04001-20), flatwashers (p/n 04041-07), spacers (p/n 43212), and serrated flange nuts (p/n 04019- 04). See Figure 3-3, page 3.