7.Install the blower assembly to the mounting bracket and secure with the mounting pin. See Figure
8.Align the blower assembly with the discharge opening of the cutter deck. Tighten the hardware for the mounting bracket. See Figure
9.Install the quick pin through the rear hole in the discharge chute mounting bracket. See Figure 3-
4.
BLOWER
ASSEMBLY
QUICK
PIN
HAIR MOUNTING
PIN BRACKET
MOUNTING PIN
TIGHTEN MOUNTING
BRACKET HARDWARE
RIGHT SIDE OF
CUTTER DECK SHOWN
(Note: Some parts not shown for viewing purposes.)
2006 GC-STC-V install art 3
FIGURE
10.Install the belt to the spindle pulley. When replacing the belt, see figure
BACK SIDE
IDLER PULLEY BLOWER
PULLEY
FRONT SIDE | SPINDLE | |
PULLEY | ||
IDLER PULLEY | ||
|
FIGURE
11.Install the new belt covers and secure. See items number 1 and number 21 on page 10 of the Blower Mounting Components section in the Illustrated Parts List for proper installation.
12.Install the hopper mounting brackets to the outside of the frame on the rear of the machine. See Figure
Hopper
Mounting
Brackets
Rear Frame
Figure 4 A GC-STT Install Art
FIGURE
13.Attach the hood assembly to the machine by installing the mounting post into the hopper mounting brackets. Secure with the ring pins and tighten the locking bolts. See Figure
Locking
Bolts
Ring Pins
Locking
Bolts
Ring Pins
FIGURE
14.Install the hose from the blower assembly adapter to the hopper hood and secure using the
15.Install the bag assemblies.
16.Using the weight support bar as a guide, identify the four corresponding mounting holes, and the existing hardware that will need to be removed in order to secure the weight support bar to the front of the machine as shown. See Figure
3