Scag Power Equipment GC-STT-CSV manual Right Side Cutter Deck Shown

Page 7

8.Install the blower assembly to the mounting bracket and secure with the mounting pin and hair pin. See Figure 3-4.

9.Align the blower assembly with the discharge opening of the cutter deck. Tighten the hardware for the mounting bracket. Install the quick pin through the rear hole in the discharge chute mounting bracket. See Figure 3-4.

11.Install the belt to the spindle pulley. When replacing the belt, see figure below.

BACK SIDE

IDLER PULLEY BLOWER

PULLEY

10.Install the new belt cover from the cutter deck to the blower mounting bracket and secure with the original belt cover plastic wing nuts.

FRONT SIDE

SPINDLE

PULLEY

IDLER PULLEY

 

12.Install the plastic belt cover and secure with the plastic wing nuts. See Page 12 of the Illustrated Parts List for proper installation.

BLOWER

ASSEMBLY

QUICK

PIN

HAIR MOUNTING

PIN BRACKET

MOUNTING PIN

TIGHTEN MOUNTING

BRACKET HARDWARE

RIGHT SIDE OF

CUTTER DECK SHOWN

(Note: Some parts not shown for viewing purposes.)

2006 GC-STC-V install art 3

FIGURE 3-4

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents OPERATOR’SMANUAL Remember Your Mower is only AS Safe AS the Operator Introduction When dumping the hopper into a disposal area Assembly Instructions Cutter Deck Right Side Cutter Deck Shown Operate and test Hopper Assembly Grass Catcher Removal Instructions Maintenance GC-STT-V Blower Housing Assembly Ref. Part No. Number Description GC-STT-V Blower Mounting Components GC-STT-V Blower Mounting Components GC-STT-CSV Hopper Components 483038 Hopper, GC-STT-CS 482732 Door, GC-CS 461626 GC-STT-CSV Decals Limited WARRANTY- Commercial Accessory Scag Power Equipment
Top Page Image Contents