Scag Power Equipment GC-STC-CS manual Locking Bolts Ring Pins

10.Install the new belt covers and secure. See items number 1 and number 21 on page 10 of the Blower Mounting Components section in the Illustrated Parts List for proper installation.

11.Install the hopper mounting brackets to the outside of the frame on the rear of the machine. See Figure 3-4.

Hopper

Mounting

Brackets

Rear Frame

Figure 4 A GC-STT Install Art

FIGURE 3-4

12.With help from an assistant, install the hopper assembly to the machine by installing the mounting post into the hopper mounting brackets and secure with the ring pins. Tighten the bolts and jam nuts. See Figure 3-5.

Locking

Bolts

Ring Pins

Locking

Bolts

Ring Pins

FIGURE 3-5

-NOTE-

The hopper dump handle can be installed on either side for operator convenience. When installing this grass catcher on a machine with the Roll Over Protection System (ROPS), the curved handle will need to be installed on the right side.

13.Install the hose from the blower assembly adapter to the hopper hood and secure using the 6-1/2" clamps.

14.Using the weight support bar as a guide, identify the four corresponding mounting holes, and the existing hardware that will need to be removed in order to secure the weight support bar to the front of the machine as shown. See Figure 3-6.

15.Install one 7/16-14 x 1-3/4" hex head bolt into each of the four mounting holes in the weight support bar, and through the matching holes in the caster support weldment. Secure this assembly to the front of the machine using the 7/16- .5" x 1-1/4" x .083" flatwashers, and the 7/16-14 elastic stop nuts. Torque hardware to 59 ft. lbs. See Figure 3-6.

FIGURE 3-6

16. Operate and test.

5