Infinity TSS-500OM Turn Off All Power Satellites, Connect the black terminals in the same way

Page 7

CENTER AND SATELLITE SPEAKER CONNECTIONS

Turn Off All Power

After placing the speakers, you are ready to connect your system. First, turn off all audio-system power. Use high-quality speaker wire to make your connections. #18-gauge speaker wire with polarity coding is included. For longer distances, #16-gauge or heavier wire is recommended. The side of the wire with a ridge or other coding is usually considered positive polarity (i.e., +). Also, consult the owner’s manuals that were included with your amplifier or receiver to confirm connection procedures.

Satellites

Observe polarities when making speaker connections, as shown in Figure 4. Connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker. Connect the – (black) terminals in the same way.

Important!

Do not reverse polarities (i.e., + to –, or – to +) when making connections. Doing so will cause poor imaging and diminished bass response. Be certain that positive and negative wire strands are completely isolated to avoid short circuits that may damage your equipment.

Center Channel

Observe polarities when making speaker connections, as shown in Figure 5. Connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on the speaker.

Connect the – (black) terminals in the same way.

Important!

Do not reverse polarities (i.e., + to –, or – to +) when making connections. Be certain that positive and negative wire strands are completely isolated to avoid short circuits that may damage your equipment.

+

Press Connector

In and Hold

Insert Bare

End; Release

Connector

Press Connector

In and Hold

Insert Bare

End; Release

Connector

Figure 5. Wiring diagram shows polarity connections for a center channel.

Figure 4. Wiring diagram shows polarity connections for one channel of a home theater system.

TSS-500 4

Image 7
Contents Total Speaker Solutions Ii TSS-500 Read FirstTSS-500 Table of ContentsPlanning Your System Infinity Total SolutionsIntroduction Unpacking the SystemPlacement Bracket on wall WALL-MOUNTINGConnect the black terminals in the same way Turn Off All Power SatellitesRear Panel Few Suggestions Subwoofer ControlsSubwoofer Connections Final Positioning Maintenance and ServiceOperation Surround ModesPowered Subwoofer SpecificationsSatellites Center Channel