TROUBLESHOOTING CUTTING CONDITIONS
CONDITION | CAUSE | CURE |
Stringers - Occasional | Low engine RPM | Run engine at full 3600 RPM |
Blades of Uncut |
|
|
Grass | Ground speed too fast | Slow speed to adjust for conditions |
| Wet grass | Cut grass after it has dried out |
| Dull blades, incorrect sharpening | Sharpen blades |
| Deck plugged, grass accumulation | Clean underside of deck |
Width of Deck | Belts slipping | Adjust belt tensions |
SGB020 |
|
|
Streaking - Strips of | Dull, worn blades | Sharpen blades |
Uncut Grass in Cutting |
|
|
Path | Incorrect blade sharpening | Sharpen blades |
| Low engine RPM | Run engine at full 3600 RPM |
| Belt slipping | Adjust belt tension |
| Deck plugged, grass accumulation | Clean underside of deck |
| Ground speed too fast | Slow speed to adjust for conditions |
| Wet grass | Cut grass after it has dried out |
Width of Deck | Bent blades | Replace blades |
| ||
SGB018 |
|
|
Streaking - Strips of | Not enough overlapping | Increase the overlap of each |
Uncut Grass Between | between rows | pass |
Cutting Paths |
|
|
Width | Width |
of | of |
Deck | SGB019 Deck |
10