Mount Tube Assembly Installation | Scag Power Equipment 37621220

2-7 Mount Tube Assembly Installation

Remove the (4) carriage bolts and (4) nuts from the rear plate. See Figure 2-7a. Remove the mower’s rear plate and secure the outer engine mount assembly P#(A0416) to the rear of the mower using the existing (4) bolts and nuts. See Figure 2-7b.

Figure 2-7a.

Remove (4)

Bolts And

2-9 Engine/Blower/Blade Assembly Installation

Place the engine/blower/blade assembly onto the engine mount arm assembly (Figure 2-9). Secure the engine/blower/blade assembly to the engine mount arm assembly by using (4) 5/16"-18 x 1-1/2" hex bolts P#(K1157) and (4) 5/16"-18 flange nuts P#(K1178).

Engine/Blower/Blade

(4) Nuts

Remove

Plate

Figure 2-7b.

Figure 2-9.

Assembly

(4)5/16"-18 x 1-1/2" Bolts

(4)5/16"-18 Flange Nuts

Outer Engine

Mount Assy.

2-8 Engine Mount Arm Installation

Slide the engine mount arm assembly P#(A0318) (Figure 2-8) into the outer engine mount assembly. Secure the engine mount arm assembly using (1) detent pin P#(J0248).

Figure 2-8.

2-10 Boot Installation

Mounting The Boot Plate

To mount the boot plate P#(B0309) to the boot P#(E0012) use (2) 3/8”-16 x 1” carriage bolts P#(K1182) and (2) 3/8”-16 flange nuts P#(K1215).

NOTE: Make certain when bolting the boot and boot plate together, that the head of the bolt is placed from the inside of the boot. This will prevent grass from collecting on the bolts.

To install the boot plate and boot to the deck, lift boot plate assembly to a 45 degree angle and slide bent tabs under the deflector shield as shown in Figure 2-10. Adjust boot as needed to insure proper fit.

The boot plate will allow you to switch from collection to discharge in seconds.

	(2)	3/8”-16 x 1 Carriage Bolts
Figure 2-10.	(2)	3/8”-16 Flange Nuts

	Engine Mount	Boot
(1) Detent Pin		Boot Plate
	Arm Assembly