Reel Mowers, Etc MM-1 owner manual

Owner’s Manual — Sunlawn MM-1

1.Turn the mower over to expose the cutting bar.

2.Using a 10mm open end wrench, turn the hex bolt at one end of the cutting bar until the cutting bar and cylinder come into contact. Then back off the bolt about 1/8 turn, until the cutting bar and cylinder are no longer in contact.

3.Make the same adjustment at the other end of the cutting bar.

4.Now check the adjustment using the small 0.05mm gauge (silver strip) supplied with the MM-1 (or any 0.05mm feeler gauge). If the gauge is held by the cylinder blades but the cylinder and cutting bar are not touching then the adjustment is correct.

5.The blades may also be tested by inserting a piece of paper vertically into the blades while turning them by hand.

!

WARNING

Be careful of injury — handle the blades carefully to avoid cutting yourself. Wear appropriate gloves or hand protection.

7