Rover Mowers Limited | Model 45TM | ASSEMBLY |
1.1 UNPACKING
1.Lift the top off the carton base and place to one side.
2.Pivot the upper handlebars into the upright position, and secure with the clamp screw and nut. Do not damage the clutch and throttle cables. Refer to separate sheet for details.
3.Roll the mower off the timber base of the carton.
4.To adjust the height of the handlebars:-
a.Loosen the lower handlebar securing bolts (A) on both sides of the mower. Figure 1.
b.Adjust the height of the handle bars, by pivoting them up or down, to suit the operator.
c.
1.2 BEFORE OPERATING
WARNING
Read and understand the safety instructions and the engine manufactuers operating instructions BEFORE using the mower.
1.Place the mower on a level surface in a well ventilated area.
2.Fill the engine crankcase with
3.Fill the fuel tank with unleaded petrol.
4.Ensure the spark plug lead is connected to the spark plug.
1.3 GRASS CATCHER
WARNING
Stop the engine BEFORE fitting or removing the grass catcher.
1. To fit the catcher. Hold the grass catcher by the top edge, hook the catcher on to the two locating pegs on the front of the mower, positioning the catcher on the two rubber stops on either side of the mower.
2. To remove the catcher. Disengage the cutter
Figure 1. Rear Viewdrive and move the throttle control lever to stop position. When the engine has stopped, hold the catcher by the top edge and lift it off the locating pegs.
1