Rover 2042 warranty Service, Cutting Deck Removal, Deck Idler Bracket

Service

Cutting Deck Removal

To remove the cutting deck, proceed as follows:

1.Place the PTO/Blade Engage knob in the disengaged (OFF) position and engage the parking brake.

2.Lower the deck by moving the deck lift lever into the bottom notch on the right fender.

3.Locate the PTO clutch under the front of your tractor. See Fig. 7-1.

Figure 7-1

4.Remove the belt guard and belt as follows Refer to Fig. 7-1:

a.Remove the hex screws.

b.Pull the belt keeper rod to the right and down to remove.

c.Remove the deck belt from around the tractor’s electric PTO clutch.

7

NOTE: If there is too much tension on the belt for it to be easily removed from the electric PTO clutch, carefully insert a 3⁄8” drive ratchet wrench (set to loosen) into the square hole found in the deck idler bracket and pivot it toward the tractor’s left side to relieve tension on the belt. See Fig. 7-2.

Deck Idler

Bracket

Figure 7-2

WARNING! Avoid pinching injuries. Never place your fingers on the idler spring or between the belt and a pulley while removing the belt.

5.Looking at the cutting deck from the left side of the tractor, locate the deck support pin on the rear left side of the deck.

24