ASSEMBLY
PLACING THE GRASS COLLECTOR ON THE TRACTOR (FIG. 6)
Fig. 6
Proceed to the following steps:
1.Lift the grass collector assembly with both hands. Slant it to an angle of approximately 40° (fig. 6).
2.Slide the grass collector on the two support brackets located on the rear of the tractor.
3.When the grass collector is properly positioned, place the decal with the triangle symbol directly opposite to the symbol on the rear of the tractor. This will assist alignment in the future (Fig. 7).
Fig. 7
! WARNING !
This tractor is equipped with a safety
PREPARATION BEFORE THE FIRST OPERATION
The tractor is shipped without gas, oil and electrolyte in the battery, for safety reasons.
! DANGER !
Lead acid batteries generate explosive gases. Keep sparks, flame, and smoking materials away from batteries. Always wear eye protection when around batteries.
BATTERY PREPARATION
Battery provides maintenance free performance. Flush cover battery is completely leakproof and spillproof when tipped to a 45 degree angle, so you do not have to worry about electrolyte leakage when performing routine maintenance.
The battery is placed under the seat, and can be accessed by tilting the seat in the upright position (Fig. 8).
NOTE: The battery is shipped with electrolyte!
DISTILLED
WATER
Fig. 8
English – 5