1.17.USB cable (option)
If you connect your WIRELESSIP5000 to a PC with the USB cable shown in Figure 3, you can charge and change settings.
When setting the WIRELESSIP5000, check whether your WIRELESSIP 5000 is directly connected to your PC with the USB cable.
Figure 3
1.18.Installing the battery
Load the battery into the battery installation section at the rear of the WIRELESSIP5000, then push in in the direction of the release button until it clicks into place.
1.19.Removing the battery
While holding down the release button, pull the battery toward the bottom of the WIRELESSIP5000 and remove it.
1.20.Charging with the desktop charger
Step 1 Plug the AC adaptor into a wall socket, then connect the connector to the rear of the battery charger.
Step 2 As Figure 4 shows, insert the WIRELESSIP5000 onto the charger until it clicks into place and the LED lights up blue.
Figure 4
Note: As Figure 5 shows, you can also charge with the optional USB cable instead of with the AC adaptor.