Operation

OPERATING POSITION

OPERATING

POSITION

Hearing Protection

Eye Protection

OPERATING TIPS

S To reduce the risk of hearing loss associated with sound level(s), hearing protection is required.

STo reduce the risk of injury associated with contacting rotating parts, stop the engine be- fore installing or removing tube. Do not oper- ate without guard(s) in place.

SOperate power equipment only at reasonable hours--not early in the morning or late at night when people might be disturbed. Comply with times listed in local ordinances. Usual recom- mendations are 9:00 a.m. to 5:00 p.m.,

Monday though Saturday.

STo reduce noise levels, limit the number of

pieces of equipment used at any one time. S To reduce noise levels, operate power blowers at the lowest possible throttle

speed to do the job.

SUse rakes and brooms to loosen debris be- fore blowing.

S In dusty conditions, slightly dampen sur- faces or use a mister attachment when wa- ter is available.

S Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches, and gardens.

SWatch out for children, pets, open windows,

or freshly washed cars. Blow debris away safely.

SUse the full blower nozzle extension so the

air stream can work close to the ground.

SAfter using blowers and other equipment, CLEAN UP! Dispose of debris in trash re- ceptacles.

BEFORE STARTING ENGINE

WARNING: Be sure to read the fuel information in the safety rules before you begin. If you do not understand the safety rules, do not attempt to fuel your unit. Contact an authorized service dealer.

FUELING ENGINE

WARNING: Remove fuel cap slowly when refueling.

This engine is certified to operate on unleaded petrol. Before operation, petrol must be mixed with a good quality 2-cycle air-cooled engine oil. We recommend McCulloch brand oil mixed at a ratio of 40:1 (2.5%). A 40:1 ratio is obtained by mixing 5 liters of unleaded petrol with 0,125 liter of oil. When mixing fuel, follow the instructions printed on the container. Always read and follow the safety rules before fueling your unit.

IMPORTANT

Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during stor- age. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, empty the fuel system before stor- age for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

HOW TO STOP YOUR ENGINE

DTo stop the engine, move the throttle lever

to the STOP position and hold until en- gine stops running.

BEFORE STARTING THE ENGINE

WARNING: You MUST make sure the tube are secure before using the unit.

DFuel engine. Move at least 3 meters away

from the fueling site.

D Hold the unit in the starting position as shown. Make sure the blower end is di- rected away from people, animals, glass, and solid objects.

STARTING

POSITION

WARNING: When starting engine, hold the unit as illustrated. Do not set unit on any surface except a clean, hard area when starting engine or while engine is running. De- bris such as gravel, sand, dust, grass, etc. could be picked up by the air intake and thrown out through the discharge opening, damaging the unit or property, or causing seri- ous injury to bystanders or the operator.

-- 5 --