Hubbell S-28 manual Cable Removal, Cable Installation, Collector Replacement, Gleason Reel Corp

CABLE REMOVAL

Use the following procedure to remove worn or damaged cable from reel prior to installation of new cable.

CAUTION

Failure to relieve all spring tension prior to removing cable could result in damage to equipment or personal injury. Follow instructions carefully.

1.Move machine serviced by reel to a position closest to reel. Springs will still be under pre-tension at this point.

2.Turn off all electric power.

3.Lock spool to prevent turning using either a spool lock mechanism or by tying off.

4.Disconnect cable from machine junction box.

5.Grip spool by hand and carefully release spool lock or tie. Slowly unwind remaining tension.

6.Again lock or tie spool to prevent rotation.

7.Remove cable from spool. Loosen U-bolt and water-tight connector and disconnect conductors from slip ring.

8.Install new cable following instruction at right.

CABLE INSTALLATION

Use the following procedure to replace cable or if reel was ordered without cable. Refer to CABLE INSTALLATION REFERENCE DRAWING, below.

1.Unspool new cable from shipping spool and lay out to eliminate twist.

NOTE: This step is not essential, but will aid in winding operation of the reel and prolong cable life.

2.Feed one end of the cable through water-tight connector on the main shaft inside the spool and into the slip ring side. (See drawing below).

NOTE: This may require that jacket of cable be stripped to allow conductors to pass through shaft.

3.Connect individual conductors to appropriate rings on collector using crimp fitting or similar connection method.

4.Tighten water-tight connector and U-bolt provided on drum wrapper segments. Do not over-tighten.

5.Wind the cable onto the reel spool by hand rotating spool in direction it turns free of spring tension.

6.Connect free end of cable to machine junction box.

7.Pretension reel and complete installation as previously described.

COLLECTOR REPLACEMENT

1.Turn off all power to reel.

2.Remove collector cover and gasket.

3.Disconnect electric leads to and from collector.

4.Remove drive stud bolt from bearing housing.

5.Remove button plug from hole in side of housing. Insert long 1/8” Allen wrench through hole and loosen two set

screws in collector locking collar Set screws are at 90O to one another..

NOTE: Older reels may have lock screws which must be removed to reach set screws holding collector to shaft.

6.Slide collector off shaft.

7.Install new collector by reversing above steps.

CABLE INSTALLATION REFERENCE DRAWING				SPOOL ROTATION DIRECTION
		INSTALL CABLE		TO WIND CABLE WHEN
	TERMINATE THIS END TO	THIS DIRECTION	POSITION CABLE	VIEWED FROM SPRING SIDE
				(STANDARD ROTATION)
		CABLE	GUIDE (OPTIONAL)
	MACHINE JUNCTION BOX
				PAYOFF
			SO THAT ROLLER
			PLATE FACES CABLE	DIRECTION–
ATTACH INDIVIDUAL	BUTTON	U-BOLT	PAYOFF DIRECTION.	OPTIONAL
	PLUG			GUIDE
CONDUCTORS TO
	LINE	WATER- TIGHT		LOCATION
COLLECTOR LEADS
	ENTRANCE	CONNECTOR
AT THIS END
	(NPT)
				PRETENSION
				HUB
COLLECTOR			PAYOFF
COVER			DIRECTION
REMOVE				SPRING
		SPRING MOTOR		MOTOR
	SLIP RING		HOOP GUIDE
			(OPTIONAL)	PAYOFF
	ASSEMBLY
			SPOOL	DIRECTION–
				OPTIONAL
		MAIN SHAFT		GUIDE
				LOCATION

HUBBELL

	GLEASON REEL CORP.
®	P.O. Box 26 • 600 South Clark St
	Mayville, WI 53050–0026
®	Phone 920–387–4120
A Hubbell Company	Fax 920–387–4189

Printed in USA Bulletin No. 040249.a