Simplicity 14HP, 11HP manual Operating the Mower, Checks Before Starting

Page 16

Operation

*2390

Figure 6. Mower Hitch

A. LeverC. Rider Hitch Brackets

B. Mower Hitch

2.On left-hand side of 34” mower, push idler pulley arm (A, figure 5) to relieve belt tension.

On right-hand side of 30” mower, pull idler pulley arm to relieve belt tension.

3.With belt tension relieved, remove belt from idler pul- ley (B, figure 5) and PTO pulley (C). Removing belt relieves tension on the front hitch assembly.

4.With lift lever down and Dial-A-CutTMcontrol set to the lowest setting, remove lift cable (D, figure 5) from mower hook (see inset illustration, figure 5).

5.Remove mower hitch (B, figure 6) from rider hitch brackets (C) by pulling spring-loaded lever (A, figure 6) forward and lifting up on hitch. Place mower hitch on ground.

6.With wheels turned fully left, remove mower from underneath right-hand side of rider.

7.To install mower, reverse above steps. Check mower belt pattern as shown in figure 7. Make sure that the mower lift cable is installed with hook torward the rear and rear trailing arms (F, figure 5) are positioned above rear torsion bar.

OPERATING THE MOWER

1.When traveling to or from the work site, fully raise the mower using the mower lift lever (A, figure 11 ). At the work site, lower mower using the lift lever.

2.Use the Dial-A-CutTMcontrol (E, figure 11) to adjust the height of the mower. Pull back slightly on mower lift lever (A, figure 10) to relieve pressure and turn clockwise to raise mower cutting height, or counter- clockwise to lower cutting height.

NOTE: Cutting height scale is located on the quadrant at base of lift lever. Scale is numbered 1 thru 4, with 4 rep- resenting the highest cutting height.

*2392

Figure 6. Mower Belt Pattern

A.PTO (Electric Clutch (Pulley)

B.Arbor Pulley (30”) Right Arbor Pulley (34”)

C.Idler Pulley

D.Front Idler Pulley (30”) Left Arbor Pulley (34”)

E.Idler Pulley Arm

CHECKS BEFORE STARTING

1.Make sure you have proper wheel or counterweights if required. See SLOPE OPERATION in the Safety Rules section. Make sure any slopes are within required limits.

2.Check that crankcase is filled to full mark on dipstick. See the engine Operator’s Manual for instructions and oil recommendations.

3.Make sure all nuts, bolts, screws and pins are in place and tight.

4.Make sure you can reach all controls from operator’s positions. If not, see SEAT ADJUSTMENT.

5.Fill the gasoline tank with fresh gasoline. Fill to bot- tom of filler neck to avoid spillage and overflow. DO NOT mix oil with gasoline. Refer to engine manual for gasoline recommendations.

10

Page 15 Page 17
Image 16
Page 15 Page 17
Contents 13HP Hydro Riders 11HP Gear Riders Mower Decks14HP Hydro Riders Page Series Page 1693048 2411G, 11HP Gear 1693050 2414H, 13HP Hydro Page Table Of Contents Rider & Mower Identification Identification NumbersSafety Rules General OperationSlope Operation Do NotChildren Service and MaintenanceTransporting and Storage Safety Decals OperationFeatures & Controls Rider Features & ControlsEngine Compartment Engine CompartmentSafety Interlock System Test 1 Engine should not crank ifTest 2 Engine should crank if Test 3 Engine should shut off ifOperation GeneralOperating the Mower Checks Before StartingStarting the Engine Selecting Ground & Engine SpeedNeutral Safety Checks Stopping the RiderPushing the Rider by Hand Hydro ModelsMowing Patterns & Tips Mulching Mower Operation Optional KIT AttachmentMulching Mowing ConditionsHow Much Grass To Cut Off Engine Speed & Ground SpeedProper Equipment Best CombinationNormal Care Lubrication Brake Pedal Pivot PointBattery Maintenance Checking the Battery FluidCleaning the Battery and Cables Servicing the Mower BladesInstalling The Blade Storage Temporary Storage 30 Days Or LessStarting After Long Term Storage Troubleshooting the Rider Troubleshooting & Repair Troubleshooting the MowerChecking the Battery Charging the BatteryJump Starting with Auxiliary Booster Battery This HOOK-UP for Negative Ground Vehicles Make Certain Vehicles do not TouchSeat Adjustment AdjustmentsBrake Adjustment Steering Gear Adjustment Steering Wheel AdjustmentMower Adjustments Side-To-Side Leveling2399 2394 Blade Brake Adjustment Transport Height AdjustmentFront-To-Back Levelling Rider Drive Belt Belt ReplacementMower Belt Specifications EngineTransmission ControlsDimensions International SymbolsMower Rider Parts & Accessories Common Replacement PartsOptional Accessories Maintenance Items

11HP, 14HP specifications

The Simplicity 14HP and 11HP ride-on lawn tractors stand out in the market for their impressive performance, user-friendly features, and innovative technologies. Designed for both homeowners and gardening aficionados, these models offer a perfect blend of power and maneuverability, making lawn care an enjoyable task rather than a chore.

At the heart of the Simplicity 14HP and 11HP models is a powerful and reliable engine. The 14HP model features a robust engine that delivers strong torque, making it capable of handling tough mowing conditions with ease. The 11HP model, meanwhile, is designed for those who require a little less power but still want dependable performance. Both engines provide smooth operation and are engineered for fuel efficiency, ensuring that users can accomplish their lawn care tasks without frequent refueling.

One of the standout features of these tractors is the signature Simplicity "Free Floating Mower Deck." This innovative design allows the mower deck to independently float over the contours of the lawn, providing an even cut regardless of terrain. This means users can achieve a professionally manicured look without the fear of scalping the grass, making it an ideal choice for uneven lawns.

Both models also come equipped with hydrostatic transmissions, allowing for seamless speed adjustments. This feature provides the operator with unmatched control, enabling them to navigate around obstacles and flower beds with precision. The ergonomic steering system enhances maneuverability, ensuring that even tight spaces can be easily navigated.

The Simplicity 14HP and 11HP tractors are designed with user comfort in mind. They feature spacious and comfortable seats, making long mowing sessions more enjoyable. The easy-to-use controls are conveniently located, allowing for a seamless operation without requiring users to take their focus off the lawn.

For added versatility, both models can be fitted with a range of attachments, including baggers, snow throwers, and even mulch kits. This adaptability ensures that the Simplicity tractors can be used year-round, handling various tasks beyond just mowing.

In summary, the Simplicity 14HP and 11HP ride-on lawn tractors embody efficiency, comfort, and adaptability. With powerful engines, innovative cutting technologies, and a commitment to user experience, these models are excellent choices for anyone looking to maintain their landscape effortlessly and effectively.
Top Page Image Contents