8
POWER STAKE-OFF
POWER T A K E - O F F K I T
Mfr’s. NO. 311
for
LANDLORD RIDING TRACTOR
For operation of Rotary Mower and Sickle Bar attach- +nts, a power
For ease of attachment follow the step; outlined below.
1. Mount “V” pulley to shaft of bevel gear assemble
( see figure 1 )
and secure in place with key and set screw. Hub of “V” pulley is to face inward. Place drive belt on “V” pulley and mount belt guard support to.:
inside surface of side plate nearest drive pulley. See‘
figure 5 for mounting bolt location. Attach the ~belt. guard to the guard support as shown in figure 1. Allow approximately 3/16” clearance between belt and hard;:
B E L T G U A R D S U P P O R T
F i g . I
2.Holding the power
bracket assembly tube.
3.Push pivot pin through the holes in bracket and tube until the position of cotter pin hole in pivot pin is as shown in figure 3. Secure in position with
r
BEVEL GEAR HOUSING SIDE PlqT’
63.2
4.Remove hex cap screw “D” from frame oftractor and mount bracket in place under lift lever quadrant. See figure 4. Position the pivot bar assembly flush against bottom of lift quadrant and
SIDE PLATE
3RIVE B
cotter | pin furnished. | mg. J |
.., | SIMPIJCITV | / P O R T W A S H I N G T O N . WIG. |