42” Snow Plow/Dozer Blade
ASSEMBLY
1.Place the blade on a flat surface.
2.install two bar stops (A, figure 2) using the two 5/l
3:Insert eyebolt (A, figure 3) thru.iug on blade and screw on 5/16 nut (B) only far enough so that it is flush with the end of the eyebolt.
4.Hook the spring (C) into the pivot frame (D). Stretch the spring with a pliers to hook springs on eyebok (A).
5.Repeat steps 3 and 4 for the other spring
6.Tighten the nut (B) on both eyebolts down to expose about 3/4” (19 mm) of thread.
?.Add the other nut (E) to each eyebolt. Hold the first nut (B) secure with a wrench and tighten the second nut (E) securely on each eyebok.
Figure 2. Bar Stop
A. Bar Stop
B. Taptite Screw, 5/l 6-l 8 x 1
Figure 3. Tension | Springs |
A. Eyebolt | D. Pivot Frame |
0. Nut, 5116 | E. Nut, 5/16 |
C. Spring |
|