Weed Eater 186100 owner manual To Adjust Throttle Control Cable See Fig, To Adjust Carburetor

Page 18

SERVICE AND ADJUSTMENTS

ENGINE

TO ADJUST THROTTLE CONTROL CABLE (See Fig. 29)

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, proceed as follows:

•With engine not running, move remote throttle control lever to “FAST” position.

•If throttle lever on engine touches high speed stop, no further adjustment is necessary. If throttle lever does not touch high speed stop, continue with adjustment procedure.

•Loosen cable clamp screw.

•Move throttle lever up until it touches high speed stop, and hold in this position.

•Tighten cable clamp screw securely.

HIGH SPEED STOP

THROTTLE

CABLE

THROTTLE

CABLELEVER CLAMP

SCREW

FIG. 29

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjustment should not be necessary. However, engine performance can be affected by differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, contact your nearest authorized service center/department

IMPORTANT:NEVERTAMPERWITHTHEENGINEGOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACTYOUR NEAREST AUTHORIZED SERVICE CENTER/ DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Model NO. WET6500A Training Safety RulesMaintenance and Storage PreparationTable of Contents Assembly Tools Required for AssemblyOPERATOR’S Position See Fig Install Handle See Figs , 4, Unpacking Carton See FigRemove Tiller from Crate Attach Clutch Cable See FigConnect Shift ROD See Fig Check Tire PressureMeets Ansi Safety Requirements OperationKnow Your Tiller FORWARD- Wheels ONLY/TINES Stopped HOW to USE Your TillerTine Operation with Wheel Drive Reverse Wheels ONLY/TINES StoppedTo Transport Before Starting EngineTurning ADD GasolineTo Start Engine See Fig Tilling HintsTine Shear Pins Adjust Wheels for Cultivating See FigsCultivating Maintenance Maintenance ScheduleGeneral Recommendations Engine AIR Filter See FigMuffler CleaningCooling System See Fig Spark PlugTiller Service and AdjustmentsTo Adjust Handle Height See Fig Tire CareTine Replacement See Figs , 25 Ground Drive Belt Adjustment See Fig To Remove Belt Guard See FigTo Replace Ground Drive Belt See Figs To Adjust Throttle Control Cable See Fig To Adjust CarburetorFuel System StorageOther Engine OILTroubleshooting Points Handle Assembly Tiller - Model Number WET6500AMAINFRAME, Left Side KEY Part NO. NO. DescriptionMAINFRAME, Right Side Transmission1.95b Tine Shield Tine Assembly Decals Limited Warranty
Top Page Image Contents