Jonsered RS44/52 manual Fitting other guards and cutting attachments

ASSEMBLY

Fitting the trimmer guard and trimmer head Trimmy SII

CAUTION! If the machine is to be used with a trimmer head, the fast idle speed must be reduced by 400-500 rpm. See instructions under the heading Carburettor.

•Fit the correct trimmer guard (A) for use with the trimmer head. Secure the trimmer guard using the 4 screws (L) and the support plate (M) as shown.

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

Fitting other guards and cutting attachments

Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. Secure the trimmer guard using the 4 screws (L) and the support plate (M) as shown.

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

A

L B

A

L B

M

C

M

C

•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.

H

•Screw on the trimmer head (H) in the opposite direction to the direction of rotation.

•Tighten the trimmer head to a torque of 35-50 Nm (3.5-5 kpm).

H

•To dismantle, follow the instructions in the reverse order.

H

•To dismantle, follow the instructions in the reverse order.

English – 19