Inventory (Figure 2) |
| |
A. | Bench Shear (Not shown) | ........................... 1 |
B.. | Safety Guard | 1 |
C.. | Work Stop Assembly | 1 |
D.. | Handle | 1 |
E.. | Hex Wrenches 2.5, 4mm | 1 Ea. |
|
| B |
|
| C |
E
D
Figure 2. Inventory.
Assembly
1.Attach the safety guard by removing the pre- installed Phillips head screws from the tool base, aligning the guard over the holes in the base, then securing it with the
|
| Phillips Head | |
Guard | |||
| Screws | ||
|
| ||
| |||
|
|
|
Tool Base
Figure 3. Safety guard attachment.
2.Attach the handle by removing the pre- installed hex bolts, flat washers, and lock nuts, aligning the holes in the handle with those in the handle base, then securing it with the just-removed hex bolts, flat washers, and lock nuts (Figure 4).
Handle Base
Handle
Figure 4. Handle attachment.
3.Attach the work stop assembly by threading it into one of the three threaded holes on the side of the tool base (Figure 5).
Note: This step is optional and only neces- sary when you plan to use the work stop. The mounting location of the work stop depends on the size of your workpiece and the opera- tion you are performing.
Mounting Hole
(1 of 3)
Work Stop | Tool Base |
Assembly |