Electrolux MT21 manual Assembly Instructions, Starting and Stopping, How to Trim

3
			Assembly Instructions
A	1
				Shaft Assembly (A)
				1.	Locate the lower shaft (A1) into the upper shaft (A2).
			2	2.	Grasp firmly and hold steady the lower shaft. Locate
					the upper shaft and snap together firmly.
				•	The unit is correctly assembled when the gap
					between the upper and lower shaft has been
					closed.
		1	2
B Mini Trim/MT21		Mini Trim Auto/
	1	Auto +		1
				Safety Guard Assembly (B) & (C)
				1.	Locate the safety guard (B1) over the cutting head
					(B2). Ensure the nylon line is fed through the hole in
	2		2		the safety guard as illustrated in fig B.
				2.	Push into location and turn safety guard in the direc-
C					tion illustrated in Fig C, until a click is heard and the
					safety guard is securely locked in position.
				•	ENSURE THE SAFETY GUARD IS SECURELY IN
					PLACE BY ATTEMPTING TO TWIST GUARD.

D	E
	Cable Restraint (D) & (E)
	1.	Form loop in mains cable and push the loop through
		the slot as illustrated in picture (D).
	2.	To secure, position loop over the hook and pull the
		cable back through the slot as illustrated in picture
		(E).

Starting and Stopping

F

WARNING

Cutting head continues to rotate after the trimmer has been switched off.

To start your trimmer

Squeeze the switch lever (F).

To stop your trimmer

Release the switch lever (F).

How to Trim

G

WARNING: The use of eye protection is recommend- ed. Do not lean over the trimmer guard whilst trim- ming, objects may be thrown by the cutting line. Do not allow cutting head to rest on the ground. Do not overload your trimmer. Overloading can be avoided by making sure the motor speed does not drop undu- ly. Disconnect the mains electricity supply before attempting any maintenance or adjustment.

1.Cut with cutting line at an angle using the tip (G).

2.Swing trimmer in and out of the cutting area taking small cuts (G).