Poulan SM132 instruction manual Troubleshooting Table Cause Remedy

Page 10

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performingall of the recommended remedies below except remedies that require operation of the unit.

TROUBLE

CAUSE

REMEDY

Engine will not

1. ON/OFF switch in

1. Move ON/OFF switch to ON.

start.

 

OFF position.

 

 

 

2.

Engine flooded.

2. See “Starting a Flooded Engine” in

 

3.

Fuel tank empty.

 

Operation Section.

 

3. Fill tank with correct fuel mixture.

 

4.

Spark plug not firing.

4. Install new spark plug.

 

5.

Fuel not reaching

5. Check for dirty fuel filter; replace.

 

 

carburetor.

 

Check for kinked or split fuel line;

 

6.

Carburetor requires

 

repair or replace.

 

6. Contact an authorized service dealer.

 

 

adjustment.

 

 

Engine will

1. Carburetor requires

1. See “Carburetor Adjustment” in

not idle

 

adjustment.

 

Service and Adjustments Section.

properly.

2. Crankshaft seals worn.

2. Contact an authorized service dealer.

 

3.

Compression low.

3. Contact an authorized service dealer.

Engine will not

1.

Air filter dirty.

1.

Clean or replace air filter.

accelerate,

2. Spark plug fouled.

2.

Clean or replace plug

lacks power,

3. Carburetor requires

3.

and regap.

or dies under

Contact an authorized service dealer.

a load.

4.

adjustment.

4.

Contact an authorized service dealer.

 

Carbon build-up on

 

 

muffler outlet screen.

 

 

 

5.

Compression low.

5.

Contact an authorized service dealer.

Engine

1. Choke partially on.

1.

Adjust choke.

smokes

2. Fuel mixture incorrect.

2.

Empty fuel tank and refill with

excessively.

3.

Air filter dirty.

3.

correct fuel mixture.

 

Clean or replace air filter.

 

4.

Carburetor requires

4.

Contact an authorized service dealer.

 

 

adjustment.

 

 

Engine runs

1. Fuel mixture incorrect.

1.

See “Fueling Engine” in Operation

hot.

2.

Spark plug incorrect.

2.

section.

 

Replace with correct spark plug.

 

3.

Carburetor requires

3.

Contact an authorized service dealer.

 

 

adjustment.

 

 

 

4.

Carbon build-up on

4.

Contact an authorized service dealer.

 

 

muffler outlet screen.

 

 

10

Image 10
Contents Manual de Instrucciones Manuel d’Instructions 530164435 10/31/03Unit / Maintenance Safety Operator SafetyFuel Safety Transporting and Storage Cutting SafetyAdjusting the Handle Attaching ShieldKnow Your Trimmer ON/OFF Switch ChokeHOW to Stop Your Unit Primer BulbStarting a Flooded Engine HOW to Start Your UnitStarting a Warm Engine Muffler Set unit on a flat surfaceCutting Methods Operating PositionTrimmer Line Advance RightWrongCheck for Loose Fasteners and Parts Inspect and Clean Unit and DE- CalsClean AIR Filter Check for Damaged or Worn PartsReplacing the Line Carburetor AdjustmentReplace Spark Plug Replacing the Trimmer HeadEngine Seasonal StorageFuel System OtherTroubleshooting Table Cause Remedy Policy of Electrolux Home Prod Ligations The U. S. EnvironmentalConsequential Damages Elec