LINE REPLACEMENT
S Replacement spools are
NOTE: Always clear dirt and debris from cutting head components when performing any type of maintenance.
SHold spool and unscrew cap by turning in the direction shown on top of the cap.
S Remove line guide ring and spool.
NOTE: When removing and/or installing spool, ensure dust cup remains installed over shaft.
Use a
REFILLING THE SPOOL WITH LINE
WARNING: Use only 0.080” (2 mm)
diameter round line. Other sizes and shapes of line will not advance properly and will result in improper cutting head function or can cause se- rious injury. Do not use other materials such as wire, string, rope, etc. Wire can break off during cutting and become a dangerous missile that can cause serious injury.
1.Cut a length of 30 feet of 0.080” (2 mm) di- ameter round Weed Eater∀ brand line.
2.Insert one end of line into center cavity of empty spool. Ensure line will feed into spool in the direction shown on the spool (counterclockwise).
3.Continue feeding line into spool, leaving 4
INSTALLING SPOOL WITH LINE
1.Install replacement spool.
2.Thread line through line guide ring.
Line through guide ring
Slot
Replacement Spool
3.Rest guide ring on spool and place line through slot. Allow line to extend 4
4.Ensure line remains in slot while screwing cap on to the shaft. Only tighten cap hand tight!
CARBURETOR ADJUSTMENT
Your carburetor is equipped with limiter caps. Carburetor adjustment is a complicated task. We recommend that you take your unit to an authorized service dealer. Damage will occur if you turn the needles beyond the limiter stops.
Feed line in direction shown on spool.
Spool
WARNING: | S | Store unit and fuel in a well ventilated area |
Perform the following | where fuel vapors cannot reach sparks or | |
steps after each use: |
| open flames from water heaters, electric |
S Allow engine to cool, and secure the unit | motors or switches, furnaces, etc. | |
before storing or transporting.
8