Poulan 545186799, PPB335 Assembly, Installing Trimmer ATTACH- Ment, Attaching the Shield

Page 9

ASSEMBLY

WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.

Examine parts for damage. Do not use dam- aged parts.

NOTE: If you need assistance or find parts missing or damaged, call 1-800-554-6723.

It is normal for the fuel filter to rattle in the empty fuel tank.

Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.

INSTALLING TRIMMER ATTACH- MENT

CAUTION: When installing trimmer attach- ment, place the unit on a flat surface for stabil- ity.

1.Loosen the coupler by turning the knob counterclockwise.

Coupler

LOOSEN

Locking/Release

Button in Primary Hole

For assembly of optional attachments (see list on page 11), refer to the ASSEMBLY sec- tion of the applicable attachment instruction manual.

ATTACHING THE SHIELD

WARNING: The shield must be prop- erly installed. The shield provides partial protec- tion from the risk of thrown objects to the opera- tor and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you. For proper orientation of shield, see KNOW YOUR TRIM-

Shipping protector

TIGHTEN

Knob

MER illustration in OPERATION section.

1.Remove wing nut from shield.

2.Insert bracket into slot as shown.

3.Pivot shield until bolt passes through hole in bracket.

2.Remove shipping protector from coupler.

3.Remove the shaft cap from the trimmer at- tachment (if present).

4.Position locking/release button of attach- ment into guide recess of coupler.

5.Push the attachment into the coupler until the locking/release button snaps into the primary hole.

6.Before using the unit, tighten the knob se- curely by turning clockwise.

Coupler Primary hole

Guide recess

Upper Locking/ Attachment shaft release

button

WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole unless otherwise stated in the applicable attachment instruction manual. Using the wrong hole could lead to seri- ous injury or damage to the unit.

Bracket

Shield

Slot

4.Reinstall wing nut and tighten securely. WingNut

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Manual de Instrucciones Manuel d’Instructions Identification of Safety Symbols Table of ContentsIdentification of Safety Symbols Operator Safety Safety RulesOptional Attachments Always wear face or dust mask if operation is dustyFuel Safety Unit / Maintenance SafetyLine Trimmer Safety Additional Safety RulesBLOWER/VACUUM Safety Edger SafetyBrushcutter Safety HandlebarHedge Trimmer Safety Cultivator SafetyPole Pruner Safety Cut from your right to your leftHigh speed causing injury Snow Thrower SafetyKnow how to stop quickly AnotherInstalling Trimmer ATTACH- Ment AssemblyAttaching the Shield Locking/Release Button in Primary HoleOperation HOW to Start Your Unit HOW to Stop Your UnitStarting a Cold Engine Starting a Warm EngineInstalling Optional ATTACH- Ments Operating PositionCutting Methods Maintenance Check for Loose Fasteners and PartsCheck for Damaged or Worn Parts Service and Adjustments Carburetor Idle Speed Adjustment Seasonal StorageFuel System Troubleshooting Table Cause Remedy EngineOther Limited Warranty Canada, contactLigations The U.S. Environmental NANCE, Replacement and Repair
Top Page Image Contents