Global Machinery Company RM1000 instruction manual Unpacking, Contents of carton

Page 6

WARNING. After switching off the machine, the cutting device continues to rotate for a few more seconds.

Only use the original type of nylon line. Under no circumstances use metal line instead of nylon.

Do not use the machine to cut grass which is not on the ground. For example, do not cut grass which is on walls or rocks.

Do not switch on the machine in enclosed or poorly ventilated spaces or in the presence of inflammable and/or explosive substances such as liquids, gasses and powders.

Only cut during broad daylight or with adequate artificial light.

Check that all grass cuttings and dirt have been removed from the ventilation vents.

Do not cross roads or gravel paths with the machine still running.

When the machine is not in use, store it in a dry place and out of reach of children.

After use, disconnect the machine from the power supply and check for damage. If you have the slightest doubts, contact an authorised service centre.

Only use the machine according to the instructions given in this manual.

Check regularly that the screws are tight.

Do not try to repair the machine or access internal parts. Contact authorised service centres only.

Do not get distracted and always concentrate on what you are doing. Use common sense. Never operate the machine when you are tired, sick or under the influence of alcohol or other drugs.

Wear goggles

Wear ear defenders

Wear a breathing mask

Unpacking

Due to modern mass production techniques, it is unlikely that your power tool is faulty or that a part is missing.

If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.

Contents of carton

Secondary handle with clamp nut and locking knob

Safety guard (2 parts)

5 Safety guard fixing screws

2 Guard washers (1 split, 1 flat)

Carry strap

6

Image 6
Contents 1000W Rear Motor Line Trimmer Contents Introduction Description of symbolsSpecifications Environmental protectionPersonal safety Safety instructionsElectrical safety Power tool use and careAdditional safety Instructions Additional safety rules for line trimmersService Contents of carton Unpacking516 Know your productSecondary handle locking knob 1115Fitting the carry strap AssemblyTo attach the two sections of the shaft Before startingChanging the line and spool Switching on and offTrimming StartingPower cable restraint General inspection Maintenance and cleaningPower cord maintenance StorageGMC customer assist