Flymo Auto instruction manual Nylon Line

USE

8

Nylon Line

J

To manually feed the nylon line

If required, line can be fed out manually. To operate, gently pull on the line whilst alternately pressing and releasing the button, on the side of the spoolholder. See fig J.

To replace nylon line. Replacement nylon line is available from most Electrolux Outdoor Products stockists. You can buy it either as spool and line complete, or as nylon line only.

Do not depress the button more than three	To replace spool and line (complete)
times. Excessive line will snag the line	1.	Take new spool and remove tape
cutter and cause the trimmer to
		holding line in place.
malfunction.
	2.	Unwind approximately 100mm of
		line and feed this through eyelet,
K		see fig K, then drop the spool into
		spoolholder smooth side
		uppermost.
	To replace nylon line on spool.
eyelet	1.	Take line and insert into hole in
		spool.

2. Turn spool clockwise to wind on required amount of line, (approx. half = 10m) and cut line to length,

see fig L. Care should be taken to

ensure that the line is neatly coiled on the spool. Failure to do so will impair the efficiency of the automatic line feed.

3. Leave approximately 100mm of line

Lunwound and feed this through eyelet, see fig K, then drop the spool into the spoolholder smooth side uppermost.

	• Ensure spool is fully located by
	gently rotating it during fitment.
	• Remember! Your Flymo Trimmer
	is designed to use only nylon line
	with a maximum diameter of
	1.5mm. Use only genuine Flymo
hole in spool	nylon line.

line